User Instructions

9 100800 862 0453 sharkclean.eu
USING YOUR STEAM CLEANER
1 Twist the upper cord holder to unwrap the
power cord completely (Fig. 9) . Plug into an
electrical socket.
2 When it’s first plugged in, the unit will be in
Standby mode. The LO and HI lights below
the Steam Control Button will blink
to indicate Standby mode.
3 To select the steam mode, press the Steam
Control Button once for LO, twice for
HI and 3 times for Standby.
4
Clean your floors with a forward and
backward motion.
5 When you need an extra burst of steam to
clean a stuck-on stain, you can use the
Steam Blaster
™
feature. Flip the head over
so that it is behind the mop body, then
tilt the mop handle down. This will cause
the the Steam Blaster™ (Fig. 10) to emit a
concentrated blast of steam onto the stain.
CAUTION: While in Steam
Blaster™ mode, do not leave
stationary for more than one
minute.
CAUTION: Do not scrub any one
area for an extended period
of time.
6 To stop the Steam Blaster™
spray, simply raise the handle.
You can then flip the mop head
back into its original position and
continue cleaning.
7
When you are done mopping,
press the Steam Control Button
until you return to Standby mode
.
8
To remove the Dirt Grip™ pad,
simply lift the mop straight up by
the handle until the Intelli-Mop
™
Head is hanging straight down.
Press down on the pad release
buttons on the neck of the mop
head
(fig 11a), and both sides of
the head will drop open, releasing
the pad
(fig 11b) .
9 Once the Dirt Grip™ pad has been
rel
eased, close the Intelli-Mop™
Head. To close, gently p
ress one
side of the
Intelli-Mop™ Head to
the floor until that side clicks into
place. Repeat on the other side.
10 When the water tank is empty,
the Steam Cleaner will stop
producing steam. You can refill
the water tank at any time as
long as the Steam Cleaner is
unplugged. Follow the water
tank filling instructions on
page 7.
NOTE:
Please wait 2 to 3 minutes
for the Steam Cleaner to cool o
before switching the mop head.
Never leave the Steam Cleaner
with a damp or wet Dirt Grip™
pad on any floor for an extended
period of time.
IMPORTANT: Make
sure you do not use
the Steam Cleaner
without attaching a
Dirt Grip™ pad and
adding water to the
water tank first.
When you are using
the Steam Cleaner
for the first time, it
might take longer
than the normal
30 seconds to
start steaming.
IMPORTANT: Do
not use on unsealed
wood or unglazed
ceramic floors. On
surfaces that have
been treated with
wax and on some
no-wax floors,
the sheen may be
removed by the heat
and steam action.
Test an isolated area
of the surface to
be cleaned before
proceeding. Check
the use and care
instructions from the
floor manufacturer.
NOTE: To prolong
the life of your
Steam Cleaner, we
recommend using
distilled water.
NOTE: Sweep or
vacuum your floors
prior to cleaning
with your Steam
Cleaner.
Fig. 9 Fig. 10
Fig. 11b
Fig. 11a