Installation Instructions

ManualsBrandsShape Products ManualsDoors & Windows44 in. x 38 in. Universal Fit Polycarbonate Window Well Cover

1. Place Window Well Cover over well. If it doesn’t

ﬁt, the steel well may be bent out of shape. Tap

Metal with sledge hammer to ﬁt cover.

Well Cover Installation Instructions

Cleaning: Window Well Covers may be cleaned with a mild solution of detergent and water. The use of harsh

chemicals or solvents may damage plastic and void warranty.

2. When straightened, place cover back over win -

dow well, centered. Mark position of holes for

clips on center of well rim with a marker. Follow

diagram below for recommended placement of

clips.

3. Remove Window Well Cover and drill a 3/16” hole

at each marked location. If it is cold out, this

can be done in the convenience of your house

or garage.

4. Mount Clips to Window Well Cover using bolts

and cap nuts provided. IMPORTANT! Put bolt

through clip, cover and washer. Secure using

cap nut provided (see below).

6. CAUTION - If your window projects above the

window well, DO NOT USE the 5 clip installation

instructions. Install using 2 clips located at the

“X’s” in the ﬁgure below. This will allow the win -

dow well cover to slide forward when the win -

dow is cranked open

Shape Products, LLC warrants its Escape Hatch Window Well Covers for a period of seven (7) years from the date of purchase. This warranty only extents to the

.esuba ro ,ecnanetniam reporpmi ,noitallatsni reporpmi ,noitaretla ,raew lamron ,esusim ,tnedicca morf egamad ot ylppa ton seod ytnarraw sihT .resahcrup lanigiro

ANY IMPLIED WARRANTIES WHICH THE PURCHASER MAY HAVE ARE LIMITED IN DURATION TO SEVEN (7) YEARS FROM THE DATE OF PURCHASE. Some

states do not allow limitations on how long an implied warranty lasts, so the above limitation may not imply to you. Shape Products, LLC. will replace a defective window

well cover free of charge,

(except for dealer labor and shipping). Contact Shape Products, LLC. at the address listed below (or see your Shape Products, LLC dealer) to

obtain service under this warrant. Proof of purchase is required and replacement is the sole remedy of the purchaser under this warranty, and in no event shall Shape

Products, LLC. be liable for any incidental or consequential damages, losses, or expenses. Some states do not allow the exclusion of incidental or consequential dam

ages, so the above limitation or exclusion may not apply. This warranty gives speciﬁc rights and you may also have other rights which vary state to state.

.llew wodniw fo mir otno revoC lleW wodniW panS .5

Adjust tension clips by loosening cap nuts. Your

Window Well Covers are now easily removable for

cleaning and ventilation.

Instruction Sheet: CS-5