Instructions / Assembly

set up
n w o d e k a t
Take Down
Shade Tech® Set-Up and Safety Instructions
J
K
L
M
N
Wheeled Bag
Step 1
Step 2
Step 3
Step 4
Reduce each leg to its shortest position (fig. I).
Hold the top of the middle frame section
where it says "CLOSE" (fig. K). Lift slightly
and slowly walk towards partner as the
frame folds in. Keep walking until the
frame is about halfway closed. Be sure to
avoid pinching your hands or fingers. Hold
outside legs and continue closing canopy
as you walk towards your partner. T h e
completely folded canopy should stand up
on its own (fig. L).
With the canopy standing, unzip the
wheeled bag (loosen cord for WX8) and
slide bag down slowly (fig. M) until entire
canopy is in. Invert the canopy and zipper
shut (fig. N).
If your canopy came with a polyethylene top,
please remove this before inserting the frame
intothe bag.
At each corner, push in the locking button
and pull the slider down slowly until the
button pops out above the slider (fig. J).
For commercial units, pull ring out and
move sliders down (fig. G).
Note: The canopy top may remain in place for easier
subsequent set-up, however, to prolong the life of the canopy
top, we recommend that you remove it during take-down.
WARNING: Before storing your Shade Tech®, be sure the
canopy top is not wet or damp. Storing your Shade Tech® while
it is even slightly damp may cause mildew. Allow your
canopy top to completely dry before taking it down. If you must
take down your Shade Tech® while the canopy top is damp,
remove the canopy top from the frame by unfastening the hook
and loop straps. Fold up the frame and lay the canopy top down,
fully open, as soon as possible and allow it to completely dry.
Set Up
Final
Step 1
Step 2
Step 3
Step 4
Step 5
Place your Shade Tech® in the center of
the set-up area. With a partner on the
opposite side of the frame, hold onto the
two outer legs and lift slightly for clearance
Take a few steps backward until you have
extended the frame a full arm’s length -
approx. 4 feet (figure A). To improve the
opening and closing action of your Shade
Tech®, spray some silicone lubricant on
the outer legs.
Hold the bottom of the middle frame
section where it forms a "V" and says
"OPEN" (fig. D). Lift slightly and slowly
walk backward until the frame is fully
extended (fig. E). Take care to avoid
pinching your hands or fingers.
At each corner, hold the leg of the frame
with one hand and lift the slider with the other
hand. Push the locking button in while pulling
the slider up until the button pops through
(fig. F). For the commercial series, sliders
will lock in place as shown (fig. G).
Place the canopy over the top of the frame
(fig. B). Use the hook and loop straps to
secure each corner of the cover to the
frame under the plastic caps or steel
bracket (fig. C).
Secure remaining side hook and loop
straps to the frame (fig. H). The adjustable
legs offer multiple height levels. Simply lift a
leg and adjust the inner leg up or down until
the button pops into place (fig. I). Repeat on
the other legs.
Before proceeding with the assembly of your Shade Tech®
Instant Canopy, please make yourself familiar with its parts
and how they make your Shade Tech® function.
Bravo Sports, 12801 Carmenita Rd, Santa Fe Springs, CA 90670
Customer Service Dept. Phone [phone]
The following parts are inside your Shade Tech® box:
1 Shade Tech® Assembled Frame
1 Wheeled Bag*
*NOTE: Your canopy may or may not come with a wheeled bag.
Please check box for list of contents.
1 Canopy Top
Do not call store regarding set up issues, missing parts or any
questions. Instead, please contact Bravo Sports directly at
800-248-5327.
E-mail: [e-mail] Check us out at www.bravosportscorp.com
A
B
C
F
G
D
E
H