Owner's manual

Roller Squeegee
Double-Ribbed Style
Assembly Instructions
Parts Shipped with Unit:

Hea
d assembly
 Aluminum handle (not pictured
)

Wrap-around brac
e (set of 2)
 Bolt bag

Hook hardwa
re bag
Tools Needed for Assembly:
 7/16” wrench (two)
 1/2” wrench
If Roller Squeegee comes without a protective cardboard tube, proceed to
Handle Instructions.
If Roller Squeegee comes with
a protective cardboard tube, follow these
instructions:
1. DO
NOT
attempt to remove the tube by cutting.
2. On one end of roller, using a 1/2” wrench, remove the hex head bo
lt, loc
wa
sher and ax
le.
3.
Slide off card
board tube.
4.
Replace axle, loc washer, and bolt as shown. Tighten.
Handle Instructions:
1.
Insert flat-tipped end of handle into channel-shaped crossbar. NOTE
: This
may be a tight fit requiri
ng working the handle back and forth.
2.
Align holes and insert middle sized bolt. Do not tighten until all ha
rdware is
in place.
3.
Place hanging hook on label side of handle. Hook should be positioned
so
squ
eegee can be hung, with roller head up, for drying or storing.
Wrap-Around Brace Instructions:
1.
Align holes of flat end of braces with holes on head assembly and inse
rt
the two sh
ortest bolts.
2.
Align holes of wrap-around end of braces with the handle, as show
n, and
inse
rt the longest bolt.
3.
Start all loc nuts on bolts. Use wrenches to tighten, being careful no
t to
over-tig
hten. Over-tightening may result in crushing the handle, thereby
compromising its strength.
Mailing Address: Shipping Address:
PO Box 1674
2666 S Country Club Rd
Warsaw, IN 46581-1674
Warsaw, IN 46580
REPLACEMENT PARTS LIST
See Reverse Side
PK90074
1/14/15
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
Phone: 844-SEYMOUR
FAX: [phone] ��
w
ww.seymourmidwest.com