Owner's manual

Chisel-Tooth Rake
Assembly Instructions
Tools Ne
eded for Assembly:
- 7/16” wrench (two)
Parts Shipped with Unit:
- Head
- Bolt bag for brace
- Wrap-around brace (set of 2)
- Aluminum handle with grip (not shown)
Assembly Instructions for Handle:
1. With rake head p
ositioned as shown (grading edge facing forward)
,
insert flat-t
ipped end of handle into channel-shaped crossbar
.
NOTE: T
his may be a tight fit requiring working the handle ba
ck and
forth.
2. Align holes and in
sert middle sized bolt. Do not tighten until all hardware
is
in place.
Wrap-around Brace Instructions:
1. Align holes of flat end of brace
s with holes on rake head, as show
n, and
ins
ert the two shortest bolts.
2. Align holes of wrap-aro
und end of braces with the handle, as shown, an
d
insert the l
onge
st bolt.
3. Start all lo
c nuts on bolts. Use wrenches to tighten, being carefu
l not to
over tighten. Over tightening may re
sult in crushin
g the handl
e, thereby
compr
omising its strength.
FULL WARRANTY
All Seymour Midwest products carry a full warranty against manufacturer defects in quality and workmanship.
Products which have been abused or worn out from normal use are excluded from this warranty.
We reserve the right to replace or issue credit on an individual basis.
PK90087
1/14/15
REPLACEMENT PARTS LIST
See Reverse Side
Mailing Addr
ess: Shipping Address:
P.O. Box 1674
2666 S Country Club Rd
Warsaw, IN 46581-1674
Phone: 844-SEYMOUR
Fax: [phone]
www.sey
mourmidwest.com
Warsaw, IN 46580