Instructions / Assembly

ManualsBrandsSeville Classics ManualsDesksairLIFT 43.3 in. Rectangular Walnut Standing Desks with Adjustable Height

airLIFT® Gas-Spring

Corner Standing Desk Converter

112020 112020

Customer Service Informaon

Telephone: (800) 323-5565

Fax: (310) 533-3899

Hours: 8:30 AM – 4:30 PM (PST)

Email: Support@SevilleClassics.com

Homepage: www.SevilleClassics.com

Models: OFF65869/70

Please contact Seville Classics for help with assembly and

to report any damaged or missing components.

Phone: 1 (800) 323-5565

Email: Support@SevilleClassics.com

Homepage: www.SevilleClassics.com

Summary of content (4 pages)

PAGE 1
airLIFT® Gas-Spring Corner Standing Desk Converter Customer Service Information Telephone: (800) 323-5565 Fax: (310) 533-3899 Hours: 8:30 AM – 4:30 PM (PST) Email: Support@SevilleClassics.com Homepage: www.SevilleClassics.com 112020 Models: OFF65869/70 Please contact Seville Classics for help with assembly and to report any damaged or missing components. Phone: 1 (800) 323-5565 Email: Support@SevilleClassics.com Homepage: www.SevilleClassics.
PAGE 2
Parts List Use Instructions 1. Pull up on both airLIFT® levers and desk top to lift. 2. Pull up on both airLIFT® levers and press down on desk top to lower. FAQS A. airLIFT® Desk (1) Q. Can I attach a monitor stand to it? What about dual monitors? A. Yes! Be sure the desk is below it’s 33 lbs. maximum weight limit. Q. What size is the base? A. Base measures 32.75 inches wide and 22 inches deep. B. Brackets (2) Q. Do I need to plug it in? A. Nope! It’s fully pneumatic.
PAGE 3
Safety Assembly Instructions Failure to follow these instructions may result in property damage or personal injury. STEP 1. Remove airLIFT® DESK (A) from box and set on flat table. Requires 2 people to lift DO NOT place devices on desk edge. DO NOT route wires through desk legs. STEP 2. Cut the plastic ties on both sides of the airLIFT® DESK (A). STEP 3. Flip TRAY (C) upside down. Attach BRACKETS (B) to underside of TRAY (C) with SCREWS (G) and ALLEN WRENCH (E).
PAGE 4
STEP 4. Hook BRACKETS (B) over the bolts on the inner legs of the airLIFT® DESK (A). Tighten bolts clockwise with included ALLEN WRENCH (E). Cable Management STEP 5. Pull up on both airLIFT® DESK levers and desktop to lift. Organize loose cables with included ZIP TIES (D). STEP 6. Place your belongings on the desktop to finish! ALWAYS route your cables through the REAR of the desk. NEVER route cables through the legs of the desk. Stick WIRE CLIPS (F) to back of the crossbar.