Use and Care Manual

ManualsBrandsSeville Classics ManualsDecorAIRLIFT Maple Classic Laptop Mobile Desk Cart

Seville

Classics

Torrance, CA 90501 USA

www.sevilleclassics.com

OFF42630V2.7

AIRLIF

T™ Classic Laptop Mobile Desk Cart

Model #: OFF42630

Thank you for choosing Seville Classics! We hope that you enjoy your new sit-stand desk.

Please read through this user guide for parts list, assembly instructions, frequently asked

questions and further contact information.

Summary of content (6 pages)

PAGE 1
AIRLIFT™ Classic Laptop Mobile Desk Cart Model #: OFF42630 Thank you for choosing Seville Classics! We hope that you enjoy your new sit-stand desk. Please read through this user guide for parts list, assembly instructions, frequently asked questions and further contact information. Seville Classics Torrance, CA 90501 USA www.sevilleclassics.com OFF42630V2.
PAGE 2
Parts List H. Medium bolt (11) A. Column M6X12 B. Mounting Plate I. Screws (2) M4X12 J. External-tooth locking washer (4) C. Top M4X12 D. Base K. Lever clip L. Wrench E. Casters (2) F. Locking casters (2) M. 5 mm Allen key 5 mm G. Long bolts (4) M6X45 Please make sure you have all the parts on this list. If you’re missing parts, contact us for replacements at (800) 323-5565 or send an email to Support@SevilleClassics.com Seville Classics Torrance, CA 90501 USA www.sevilleclassics.
PAGE 3
Assembly Step 1. Remove Column Cap Tool required: None Set the column (A) on the floor with the column plate facing up. Pull off the plastic cap. Step 2. Install Mounting Plate Tool required: 5 mm Allen key (M) Align the three holes in the mounting plate (B) with the three holes on the column plate (A). Affix the mounting plate to the column with three medium bolts (H) through the top. Tighten bolts with 5 mm Allen key (M) until snug. Step 3.
PAGE 4
Step 4. Install Column to Desktop Tool: 5 mm Allen key (M) Turn the column assembly upside down. IMPORTANT: Make sure the arrow stickers on the mounting plate (B) and the top (C) are on the same side. Align the holes on the mounting plate (B) with the remaining holes in the desk top (C). Align the lever with the lever clip (K). Affix the column assembly (B) to the desk with eight medium bolts (H). Tighten bolts with the Allen key (M) until snug. Step 5.
PAGE 5
Step 6. Install Casters Tools required: Wrench (L) Begin with the two locking casters (F). Mount the locking casters to the legs on the same side as the adjustment lever handle. Screw in the casters by hand as far as possible, then tighten until snug with the included wrench (L). Mount the remaining two casters (E) to the remaining legs of the desk. Tighten until snug with the included wrench (L). Flip the desk on to its wheels.
PAGE 6
Use Instructions 1. 2. 3. 4. 5. Roll desk into desired position. Lock casters to prevent the table from rolling. To lift, pull up on the adjustment lever. To lower, pull up on the adjustment lever while pressing down on the table top. Release adjustment lever to lock in table height. FAQs Q. Can I use it without the wheels? A. No. The desk base does not sit flat and is unstable without wheels. Q. How high and how low can my desk go? A. Maximum height is 41.7 inches. Minimum height is 24.4 inches. Q.