Installation Guide

22
T. Apply mortar so that the long
leg of the anchor is embedded
in the vertical joint.
4T
U. Follow this procedure for the rest of the blocks in the
ÀUVWURZLQVWDOOLQJDSDQHODQFKRUDIWHUHYHU\
2 blocks.
V. Check periodically to ensure that the glass blocks
are straight, level and plumb.
Note:,I\RXÀQGDSUREOHPDGMXVWWKHEORFNLQWR
place with a rubber mallet before proceeding.
W.Using a polyfoam brush, remove
 H[FHVVPRUWDUDQGÀOODQ\YRLGVRQ
both sides of your panel.
4W
S. Install a vertical panel anchor after
the second block and screw the
short leg of the anchor
to the curb. All panel
anchors should be
attached using #12 x 1"
zinc-plated head screws
or equivalent. Use two
screws per anchor.
Note: If attaching
the panel anchors to
tile or masonry, plastic
screw anchors should
be used.
4S