Installation guide

48 Sun Java System RFID Software 3.0 Administration Guide • February 2006
All device adapters support a basic set of properties, unless otherwise specified in
the configuration section for the specific adapter. The common properties are
described in the following table.
TABLE 2-4 Device Adapter Common Properties
Property Description Values
LogLevel Specifies the detail of logging
information to be generated by the
adapter. This property overrides the
system-wide logging level for the
component.
Also see “Additional Information for
Common Properties” on page 50.
In descending order the
LogLevel values are:
• SEVERE
• WARNING
• INFO
• CONFIG
• FINE
• FINER
• FINEST
• OFF - turns off logging
• ALL - enables logging
of all messages
hostname Specifies the IP address or hostname
of the network- based RFID reader.
In the case of RFID readers
connected to a serial Ethernet
converter, hostname specifies the
address of the Ethernet converter.
For example:
192.168.1.25
port Specifies the port number where the
RFID reader listens for connections
from the RFID Event Manager.
For example: 9011
readerepc An EPC value associated with the
reader that identifies it in the EPC
network. This property should not
be confused with the EPC values
that the reader obtains from the tags.
The RFID Event Manager uses this
value to identify the source of the
read events.
Also see “Additional Information for
Common Properties” on page 50.
For example:
urn:epc:tag:gid-
96:1.255.1