Installation guide

152 Sun Java System RFID Software 3.0 Administration Guide • February 2006
Adapter for Matrics Readers
This adapter is used to communicate with the Matrics RDR-001 and Matrics AR-400
RFID readers. The adapter properties are shown in the following table.
port default = 80
readerepc
autoread
communicationTimeo
ut
scanDuration
Additional Properties
Also see “Additional Properties Information for Mercury 3 and
Agile 1 Reader” on page 150.
protocol Use this property to
specify the protocol to be
used during data
capture.
This reader supports three data capture
protocols:
• EPC0
• EPC1
• ISO18000-6B
Default = ALL
readerepcUHF1,
readerepcUHF2,and
so on.
readerepcUHF1
specifies the EPC for
Antenna UHF1.
This EPC reader value is
associated with the
corresponding UHF1,
UHF2, UHF3, UHF4,
UHF5, UHF6, UHF7 and
UHF8 antennae.
Replace UHF1 with
UHF2, UHF3 and so on
for the other antennae.
A sample value =
urn:epc:tag:gid-96:1.2.1.
antenna This reader supports two
antennae for each
protocol: UHF1, UHF2
and HF1, HF2. This
property specifies the
antenna from which to
read.
The default is to enable all the antennae
for the RF protocol that has been
enabled (see protocol). For example,
if CC915 (the default) is selected, both
antennae UHF1 and UHF2 will be active.
TABLE A-8 Adapter Properties for Mercury4 and Agile 2 Readers (Continued)
Property Name Description Values