User Manual

Multi-room mode
52
Single room – installation and startup
▷ Install all receivers in one rack (see „Installing a single receiver in a
fixed location“ or „Installing two receivers next to one another in a fixed
location“).
▷ Wire all receivers (see „Connecting the receiver“).
▷ Mount all antennas as recommended (see „Recommendations on an-
tenna mounting“).
▷ Make sure that all receivers are switched off.
▷ Switch the first receiver on. This receiver will be the master receiver.
▷ Pair a transmitter to the receiver. Only do this if necessary. The receiv-
er/transmitter sets are already factory pre-paired on delivery.
▷ Wait until the status LED on both the receiver and the transmitter lights
up green.
▷ Perform a walk test to check the transmission power (see „Performing
a walk test (reception quality)“).
▷ Switch on all other receivers. These receivers synchronize with the
master receiver. Make sure the master receiver remains switched on.