Users Manual

Using the EM 9046
74 | Digital 9000
The currently installed firmware version and the installable firmware
(“Update to Firmware”) of connected boosters/transmitters are displayed
in the “Antenna Booster” area of the main screen.
To update the firmware of the boosters:
왘 Using the jog dial, select the “Antenna Booster” area of the main screen.
The “Antenna Booster” area is highlighted in blue.
왘 Press the jog dial.
The firmware is updated. The update process can take up to 40 seconds.
Do not interrupt the transmission during the update process.
To read out and, if necessary, update the firmware of your transmitters:
왘 Make sure the accupacks of your transmitters are fully charged.
왘 Using the jog dial, select the “Transmitter” area of the main screen.
The “Transmitter” area is highlighted in blue.
왘 Press the jog dial.
The infra-red interface D is activated and flashes blue, the “Start
update” menu entry is highlighted in blue:
왘 Place the infra-red interface of a transmitter in front of the infra-red
interface D of the EM 9046.
The currently installed firmware version of the transmitter and the
installable firmware are displayed.
왘 Press the jog dial.
First, the transmitter is read out and “Scanning transmitter ...” appears in
the menu selection of the receiver’s display panel. Then, the transmitter
firmware is updated: the infra-red interface flashes faster, “Updating
transmitter ... (ca. xx s)” appears in the menu selection of the receiver’s
display panel together with a time specification in seconds. Do not inter-
rupt the transmission during the update process.
Update to rmware:
Antenna booster
10-11-30-11
RF IN A:
Firmware:
AB9000_2
10-08-10-10
RF IN B:
Firmware:
AB9000_2
10-08-10-10
Start update
Transmitter
SCAN MODE
Transmitter:
Firmware:
...
...
New rmware ...