Instruction manual ew D1
Table Of Contents
- Contents
- Important safety instructions
- Optimum sound the easy way
- Package contents
- Product overviews
- Putting the products into operation
- Avoiding sources of interference
- Direct line of sight recommended
- Putting the receiver into operation
- Fitting the device feet
- Mounting the rack mount “ears”
- Connecting the rod antennas to the receiver
- Mounting the receiver into a 19" rack
- Mounting a single receiver into a rack
- Mounting the rod antennas to the front of the rack
- Mounting two receivers into a rack
- Connecting the receiver to a mixing console
- Connecting receivers in a network
- Connecting the receiver to the power supply system
- Putting the bodypack transmitter into operation
- Preparing the headset microphone for use
- Attaching the clip-on microphone to clothing
- Putting the handheld transmitter into operation
- Recharging the accupack
- Using the products
- Switching the devices on or off
- Checking the charge status of the batteries or accupacks
- Checking the RF signal level
- Muting the bodypack transmitter or the SKM-S D1 handheld transmitter
- Pairing a receiver with a transmitter
- Identifying paired devices
- Using the devices in multi-channel operation
- Switching between the standard display and the extended standard display
- Using the operating menu of the receiver
- Using the buttons for navigation
- Overview of the operating menu of the receiver
- Changing the name of the radio link
- Activating/deactivating the low-cut filter
- Adjusting the equalizer
- Adjusting the de-esser
- Activating/deactivating the dynamic compression
- Resetting the audio settings
- Coarsely adjusting the output level of the receiver (Mic/Line)
- Fine-tuning the output level of the receiver
- Activating/deactivating the lock mode
- Activating/deactivating the MUTE switch of the transmitter
- Adjusting the display brightness
- Calling up help functions
- Retrieving system information
- Resetting the receiver to the factory default settings
- Changing the network configuration
- Displaying the IPv6 address
- Displaying the MAC address
- Performing a walk test (checking the reception quality)
- Controlling, monitoring or updating devices via the network
- Cleaning and maintaining the products
- If a problem occurs ...
- Specifications
- Accessories
- Manufacturer Declarations
21
Putting the products into operation
왘 Connect a standard network cable (at least Cat 5) to the LAN Ethernet
socket of your receiver.
왘 Connect your receiver to the Ethernet switch or the dual-band WiFi router.
왘 Connect either a computer to the Ethernet switch or connect the computer
or the mobile devices to the WiFi router.
The yellow LED at the rear of the receiver indicates the connection status.
왘 Use a strong password and a strong encryption algorithm to protect your
WiFi or your router against unauthorized access.
왘 Deactivate the WiFi router‘s 2.4 GHz frequency band in order to minimize
interference to the radio links.
To update the firmware of your devices:
왘 Establish an Internet connection with your mobile device or computer to
download the current firmware.
Connecting the receiver to the power supply system
Only use the supplied power supply unit (NT 12-4C or NT 2-3). It is designed
for your receiver and ensures safe operation.
If you use the NT 2-3 power supply unit:
왘 Slide the supplied country adapter onto the power supply unit.
To connect the power supply unit:
왘 Pass the cable of the power supply unit through the cable grip as shown on
the left.
왘 Connect the hollow jack plug of the power supply unit to the DC IN socket
of the receiver.
왘 Plug the power supply unit into the wall socket.
Yellow LED … Connection status
... lit The receiver is connected to the network.
... off The receiver is not connected to the network.
NT 2-3NT 12-4C