User's Manual

▌MOUNTING OF THE WAP7301AG ACCESS POINT
WALL MOUNT/JUNCTION OR GANG BOX MOUNT
1. Wall: Using the mounting bracket (Figure 1) as a mapping kit to wall.
Choose a location that allow the LAN cables to come out of the wall within the
rectagular hole on bracket. Place the bracket against the wall. Decide two
holes to use in order to mount the bracket. The two holes should be on
opposite sides in order to hold off to the wall.
Junction/Gang Box: Place the bracket over the junction box with the
captive screw on the left side and the flat plate against the wall. The bracket
should be attached to a vetical surface. Align two of the bracket holes with two
of the box’s holes. Using the two pan head machine screw, attached the
bracket to the box using the aligned sholes.
2. Mark the two hole centers. And screw in the provided plastic anchors into the
holes.
3. Attach the bracket using the provided two screws.
4. Connect the LAN Cable from the wall and attached the AP to the mounting
bracket. The captive screw will be used to lock the AP in place.