User`s guide

40 User’s Guide

9.0 APPENDIX A

Your Spectra keypad can display data one of two ways

when you to program the following parameters :

• User Access Codes (see section 3.4)

• System’s Clock (see section 2.5.8 & section 5.4)

• Auto-Arm Time (see section 4.9)

Do not read the following if you have not read the

above mentioned sections.

After entering the 3-digit section you wish to program, the

[

ENTER] button will flash. If a value is programmed, the

number corresponding to the first digit of the programmed

value will also illuminate. At this point, you can begin

entering the required data. After entering a digit, the

number corresponding to the following programmed digit

will illuminate and so forth. For example, if you wish to

change User Code 004 from 123456 to 454545, after

entering section [004], button [1] will turn on. Press the [4]

button and button [2] will turn on, then press the [5] button

and button [3] will turn on...

After entering the desired 3-digit section and before

entering any data, press the [

ENTER] button to access the

Data Display Mode. The [

ARM1], [ARM2] and “READY” Lights

will flash. Once in the Data Display Mode, pressing the

[

ENTER] button will scroll through the digits of the current

section. When viewing the last digit in the section, pressing

the [

ENTER] button will automatically exit the section.

1686EU04.fm Page 40 Tuesday, August 13, 2002 10:01 AM