ASSEMBLY INSTRUCTIONS Description Item No. : SALERNO 48X48X66 TABLE : T-4848XB ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PART LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: NO Description Qty A Top 1 Sketch NO Description Qty B Leg 4 Sketch HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Long bolt (M8 x 70mm) 3 Flat washer (2 x 8.
STEP 1 Attach legs (B) to the top (A) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (4). STEP 2 Unlock the table top (A) from both sides underneath the top as shown below. Pull the two parts of the table top apart. ITEM NO.
STEP 3 Place the butterfly leaf in the center of the open table top, as shown below. Note: The metal swivel bar bracket is very flexible and a slight twist of one half of the leaf can get the leaf into alignment. With one of these tops opened and in the topside up position and can be attached to the base to accomplish this too.
