User`s guide

Arming and Disarming

All/Perimeter System Disarming

Disarming: While the system is armed, you can only enter the

premises through an entry/exit delay door without causing an alarm.

After opening the door, the Security Command keypad sounds a

prewarn tone to remind you to disarm the system. You must disarm

the system before the prewarn tone expires or an alarm on the door

zone will occur.

During the prewarn tone, the keypad displays ENTER CODE:. Enter

your user code to disarm the system.

Alarm Display: After disarming, the keypad displays any zones that

tripped or any transmission problems that occurred during the

armed period. All burglary zones are then disarmed and any

bypassed zones are automatically reset.

Disarmed Message: The keypad displays ALL SYSTEM OFF after

the system disarms.

Central Station Report: A report of the system disarming can be

transmitted to the central station. This is optional and can be

programmed for you at any time.

Disarming an All/Perimeter System

1. During the entry delay time, the keypad displays ENTER

CODE:. Enter your user code.

2. The keypad then displays any zones that went into alarm or any

communication problems that occurred during the armed period.

3. The keypad next displays ALL SYSTEM OFF to confirm the

system is disarmed.

Disarming During an Alarm

1. While the alarm bell or siren is sounding, enter your user code.

The keypad displays DISARM SILENCE.

2. Press the SELECT key under DISARM to disarm the system

and silence the alarm.

The keypad next displays ALL SYSTEM OFF to confirm the

system is disarmed.

3. Press the SELECT key under SILENCE to stop the bell or siren

but NOT disarm the system.

If you do not press any SELECT key, or you press the

COMMAND key, the system will automatically disarm and

silence the alarm.

4. If your system is programmed to send an Abort (alarm cancel)

report to the central station, the keypad displays

ALARM CANCELLED.