Installation Instructions

192.168.1.9
Resetting the
Securitron Netlink
• To reset the Securitron Netlink to factory
default user name and password press and
hold the Reset button for 10 seconds.
• To reset the Securitron Netlink to factory default user
name, password, IP address, certificate, and Cipher Suite
settings, press and hold the Reset button for 30 seconds.
• After releasing the button, the Securitron
Netlink will reset and reboot.
• Depending on the firmware revision, the Securitron
Netlink may default to DHCP after reboot. If
a DHCP server is found, an IP address will be
assigned. The LifeSafety Power scan software,
or a third party software must then be used to
find the IP address of the Securitron Netlink.
Configuring the
TCP/IP Settings
1 In the menu bar at the top of the browser
screen, click the Configure link.
2 In the TCP/IP Settings block of the Configuration
screen, set the TCP/IP settings to the
desired values for the network to which the
Securitron Netlink will be connected.
Consult your IT department for
information on these settings.
• After completing the TCP/IP settings, click the Submit
button in the bottom right corner of the TCP/IP
Settings box. Note that the new TCP/IP settings will
not take effect until the Securitron Netlink is rebooted
or power to the Securitron Netlink is cycled.
• If the Securitron Netlink is connected to a DHCP
network and DHCP is enabled, the DHCP server will
automatically configure the TCP/IP settings. Note that
you will need the Network Scan tool available at http://
www.lifesafetypower.com/support/software-firmware-
downloads to locate the Securitron Netlink's IP address
before logging into the Securitron Netlink board.
NOTE: The port number used by the Securitron
Netlink can also be set in the Port# field. By default
the Securitron Netlink is set to use port 80. To
disable HTTP access and only allow access via
HTTPS, check the “Disable HTTP” selection.
NOTE: To access the Securitron Netlink board from
outside the installation site’s firewall, the firewall
must have the ports used by the Securitron Netlink
for http/https, and SNMP (if used) open. See your
IT department for firewall port opening details.
24