User Manual

ENFORCER Access Control Keypad

SECO-LARM U.S.A., Inc.

Programming the Super User Code (cont.):

2. To toggle operation of the output ON or OFF:

2580 # 7

NOTE:

• This function is used to leave the output active for extended periods of time.

• While the output remains active, the green LED remains lit.

• Do not forget to deactivate this function after its use is no longer required.

• It is recommended to only use this function with fail-safe locks. Fail-secure locks may be

damaged by staying activated for too long

3. To temporarily pause or restart the timed output disable period:

2580 # 8

NOTE:

• This function is used to enable the operation of the output if it was disabled using the auto-

disable function (see pages 18~19).

• When the output auto-disable function is inactive, the red LED will ash steadily. This

indicates that the output may now be used.

4. Disable or enable the output (toggle, regardless of programming):

2580 # 9

NOTE:

• This is used to prevent users from accessing the protected premises.

• For more information on programming timed or toggle mode, see “Programming the Output

Mode and Output Timing” on page 16.

• The red LED will remain steady on while the output is disabled.

• For safety reasons, the egress button works regardless of whether the output is enabled or

disabled via the super user code.

• The super user code continues to operate the output even while that output is disabled.