User's Manual

LOG N-3
24
4.3.2 Data of a Lift&Shift group
To access the measured data of a Lift&Shift group, proceed as follows:
► In the start screen, tap LOG N-3.
► Tap Lift&Shift.
► Select the desired logger group in the Groups list.
► Select the desired measured data from the Data list.
The measured data display opens. The measured values of the first logger of the group
are displayed in a diagram.
X-axis … course of measurement over time
Y-axis … level in dB
Each bar represents a single measurement.
The height of the bar represents the level.
The colour of the bar represents the frequency.
0 Hz 3300 Hz
The horizontal green line represents the set alarm threshold.
Below the diagram, there is a drop-down list. It contains all loggers, listed using their ID.
► To open the measured data of a logger, tap on the desired logger in the list.
You can narrow the chart view to any time range.
Option 1:
► Touch a point on the diagram and slide your finger to the side to highlight the desired
area.
Changing loggers
Zoom