Instructions / Assembly

ManualsBrandsSeasonGuard ManualsDoors & Windows40 in. x 97.5 in. Charcoal Retractable Screen Door

Thank you for purchasing the Seasonsguard+ retractable screen door by

Retractaway

This product was designed to work with all exterior hinged doors but you may

require additional instructions if your door has the following specifications:

1) The molding on the sides of the door has an angle more

than ¼ inch above top of door frame

2) The bottom sill can not be recessed more than 1” from

your brick mould

3) The door frame is not level or square

If your install does not have the issues above, please continue with the

installation. However, should your install have any of the above issues, please

visit our website at www.retractaway.com or contact customer service for

solutions

For customer service, parts or warranty issues: visit our website www.retractaway.com or email

customercare@jrhome.com

Summary of content (4 pages)

PAGE 1
Thank you for purchasing the Seasonsguard+ retractable screen door by Retractaway This product was designed to work with all exterior hinged doors but you may require additional instructions if your door has the following specifications: 1) The molding on the sides of the door has an angle more than ¼ inch above top of door frame 2) The bottom sill can not be recessed more than 1” from your brick mould 3) The door frame is not level or square If your install does not have the issues above, please continu
PAGE 2
BEFORE INSTALLATION CAREFULLY open box and lay contents on a flat surface preferably directly in front of the door frame that you are installing the screen door onto. DO NOT unwrap the contents of the shrink wrapped parts. The wrap is designed to ensure that you can make an even, accurate cut of your top and bottom tracks and sill plate. VERIFY that your install does not match any of the qualifications from the cover page of this manual. If it does please contact customer support or go to www.retractaway.
PAGE 3
INSTALLATION D. LAYOUT mounting plate, top track and sill track on a flat surface as close to your install door frame as possible TIP – start your layout by positioning your top track on the floor closest to your door, then lay your mounting plate on the same side as the hinges of your door, your sill track should now be farthest away from your install door E. INSERT your top track into your mounting plate. Tip – slightly extending the inner PVC tube will allow you to make the connection easier F.
PAGE 4
INSTALLATION J. FASTEN mounting plate There are three holes provided at the top and bottom of the mounting plate, choose only one of the holes that best fits your install. Use the drill bit provided and drill two pilot holes (1 top and 1 bottom) Use the two patented mounting plate screws (part #8) to secure the mounting plate K. FASTEN Bottom and Top track Insert the drill guide into the bottom track endcap and drill a pilot hole.