Oven User Manual

ANTB-TSP DEVICE
Rfyour range is removed for cleaning,
servicing or any reason, be sure anti.
tip device is re-engaged properly
when the range is replaced. Failure
to take this precaution could result in
tipping of the range and cause injury.
When replacing the range:
, Hook the loose end of the chain onto the bracket by
slipping the nearest link of the chain into the slot in
the bracket, making sure the chain is pulled as tight
as possible and that there is no excess slack in the
chain after chain is attached to the brackeL
2_
• Excess slack in the chain could allow the range to
tip over.
Slide the range all the way back into the counter°
Once the range is pushed back in place, there wilt be
a small amount of slack in the chain. This is normal.
NOTE: To insure the device is installed and re-en-
gaged properly, carefully try to tip the range
forward. The device should secure the range
and not allow it to tip.
BRACKET/_
OPTIONAL jii!!i
LOCATION
CHAIN _"
BRACKET/"_:::_;:::::::::::::
FACTORY ;i!:::ili!i::::f:i::i:::,i!
LOCATION
(Electric model shown;
Opposite side used for Gas models)
REPLACIING THE OVEN LIGHT
Be sure that the light switch is in the OFF position.
Do not touch hot oven bulb with wet
hands. Do not wipe oven light area
with wet cloth, Unplug or disconnect
the electrical supply to range before
removing,
Never touch the electrically live collar on the bulb when
replacing it.
Electrical power must be shut off if you have to
replace a broken bulb.
1. Removethethreescrewsandliftofftheg]assretainer,
glass cover and gaskeL
2. Replace the bulb with a 40 watt appliance bulb. An
appliance bulb is smaller than a standard 40 watt
household bulb.
3. Replace the gasket, glass cover and glass retainer.
Tighten screws securely.
GLASS
RETAINER
BULB / / j
BULB 1 ,t_
COLLAR
19 NGMNT14