User`s manual

TowerRAID TR5UT User’s Manual Ver. 091007

4.5.3.2 THE HDD TRAY LED

DESCRIPTION

GREEN

(UPPER)

GREEN

(LOWER)

HDD Unplugged / No Power Off Off

HDD plugged (Idle) On Off

HDD plugged (Active) Blink (On) Off

Error State (One or More Bad Partial Volumes) Off On

HDD Rebuild (A Physical Partition is being Rebuild; i.e. Mirroring Mode) On Blink (On)

4.6 MODE SETTING

The TowerRAID TR5UT/TR5UT-B with the device’s LEDs to indicate status. To select a storage policy in this mode the first

time that a new factory-shipped product is used, ensure that the hard disk drives are installed; turn off the power before

set the MODE SWITCH on the back of the TowerRAID TR5UT/TR5UT-B to the desired Storage Policy. To change the

storage policy thereafter, set the MODE SWITCH to the desired position and press and hold the recessed SETUP

BUTTON, than power on to create the new virtual volume(s). Creating new virtual volumes will destroy any existing data

that existed on the previous volume.

Note: Before reconfiguring a volume, back up your data and delete previously defined partitions.

4.6.1 CLEAN MODE

The CLEAN MODE storage policy requires a minimum of 1 drive to implement.

1. Turn off the power.

2. Set the MODE SWITCH position to CLEAN.