Installation guide

To change the SCSI identification on a T800-series tape drive, first power down the tape drive. The SCSI identification is
read by the system when the tape drive is powered up. If you change the SCSI identification display after power-up, the
new identification will not be registered by the tape drive. Any attempts to access the tape drive will result in an
application error.
Verify that the single-ended SCSI terminator (part number JC-005TRM) is installed in the lower port on the rear of
the tape drive. If it is not installed, connect it to the lower port and securely clip it to the tape drive (See Figure
3-3).
4.
Install only a single-ended SCSI terminator on the tape drive. Do not install a differential terminator, as it
could damage the tape drive and/or SCSI PCI card.
Figure 3-3. SCSI Terminator: Stand-Alone T800-Series
Installing Tape Drives
file:///H|/CSDoc/leoinstall/chapt3.htm (3 of 12) [01/14/2000 3:50:46 PM]