User`s manual

64
14.8 Setup of the Micropolis 3243av 4 GB hard drive.
These are the two connectors that should be configured on the 3243av:
TP F
R
OM BUS
This is the onl
y
j
umper that
should be
installed on W2
PO
W
E
R
and SCS
I
CONNECTORS
W
2
R
ed, B
r
o
w
n & Black
wires on the bottom
To Data-Ex
p
r
ess
B
R
N
R
E
D
B
L
K
R
ea
r
Vie
w
of the d
r
ive in the mounting
p
osition Bottom Vie
w
of the d
r
ive
W2 should only have one jumper to set the termination power from SCSI bus. That position is marked in
the drawing above.
Remove the two terminator resistors RN1 and RN2 (10 pin SIP resistor)
The Data-Express carrier should be connected to the drive with 3 cables:
1. Power Cable
2. SCSI Cable
3. SCSI ID number cable: this cable is supplied by Kingston with the Data-Express and has one 3 pin
connector that connects to the Data-Express carrier, and three 2 pin connectors that should be
connected to the drive. Note that each of those 3 wires are connected to only one side of the 2 pin
connector, that side with the wire should be connected to the bottom row of the DIP connector if you
are looking straight to the front of the drive.
Extra care should be given as to not have cable number 3 described above be caught between the drive
and the Data-Express carrier chassis.