Installation Guide

ManualsBrandsSea Gull Lighting ManualsLighting & Fans1-Light Warwick Autumn Bronze Bathroom Vanity Light

INSTALLATION AND SAFETY INSTRUCTIONS

FOR YOUR SAFETY

GENERAL

ASSEMBLY

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF; EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER SET AT OFF.

ou don't need special tools to install this fixture. Be sure to follow

the steps in the order given. Read instructions carefully.

If you are

unclear as to how to proceed, consult a qualified electrician.

Carefully remove the fixture from the carton and check that all parts

are included, as shown in figure 1 and 2. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

Installation And Safety

Instruction

HC-990

072706

Fill In Item Number On Carton And

File This Sheet For Fixture Reference. ITEM#_______________

Line art shown may not exactly match the fixture enclosed.

wev

er, the installation instructions do apply to this fixture.

GREEN

GROUNDING

SCREW (G)

NIPPLE (F)

*OUTLET

BOX

SCREWS

MOUNTING BAR (D)

*WIRE CONNECTORS

*GROUND WIRE

*OUTLET BOX

GROUNDING AND MOUNTING BAR LOCK UP

FIGURE 2

*NOT INCLUDED

NUT

(E)

*OUTLET BOX

CANOPY (I)

CAP NUT (H)

GLASS (J)

RETAINING

RING (M)

FIGURE 1

*NOT INCLUDED

Summary of content (2 pages)

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS FOR YOUR SAFETY ASSEMBLY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER SET AT OFF. Carefully remove the fixture from the carton and check that all parts are included, as shown in figure 1 and 2. Be careful not to misplace any of the screws or parts which are needed to install this fixture. GENERAL You don't need special tools to install this fixture.
PAGE 2
INSTALLATION HC-990 IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX. STEP 1: Using outlet box screws (not supplied) fasten mounting bar (D) to outlet box through slots in mounting bar (D). STEP 2: Thread nut (E) onto nipple (F) so that 5 threads are exposed above nut (E). Thread that end of the nipple (F) into mounting bar (D) and tighten nut (E) against mounting bar (D). STEP 3: A. Take note of the color of the wire(s) on your fixture.