Instructions / Assembly

T48706_2018 New Packaging - Elite Spreader Instruction Pamphlet
10/5/17 LB 8.5x11
R5
The Scotts Advantage®
ELITE
SPREADER
Wheel Hubcap (2) Cotter Pin (2) Washer (2) Wheel (2)
b.
d.
c.
a.
e.
b.
f.
• 20% faster application - 6ft spread
pattern vs stan
d
a
r
d
5
f
t
s
p
r
e
a
d
p
a
t
t
ern
• Dual Rotor Technology delivers the most
accurate spread pattern ever
• 10” never-at tires conquer any terrain
• Stainless steel construction on select
features for long-lasting durability
• Hopper holds 20,000 sq. ft. of Scotts®
lawn products
• EdgeGuard® Landscape Protection System
safeguards landscaping and prevents
fertilizer from being thrown onto owers,
driveways, and sidewalks
• Scotts No-Quibble Guarantee®
LB10149
To use The EdgeGuard® Landscape Protection System:
How to Apply:
1. Make perimeter pass with EdgeGuard® on to protect non-lawn areas.
2. Make parallel internal passes 6 ft. apart to ensure even coverage.
3. Release trigger when making turns or when you stop.
Maintenance:
• Never leave unused product in the spreader. Pour leftover material
back into the package and seal package tightly.
• If product lands on any hard surface such as a driveway, sidewalk, or
road, sweep the product back onto the lawn to keep it from being
washed into the storm sewers and ultimately surface waters.
• Wash spreader thoroughly after use, including the underside, and
allow to dry before storing.
• Periodically spray lubricant on all rotating parts to ensure smooth
operation and to extend life.
• Do not allow product and/or rinse water to enter storm drains or sewers.
Healthy Lawn, Healthy Environment:
Feed your lawn regularly. Fertilizer applied at the right time in the right amount can have a signicant impact on
the health of your lawn. When combined with proper mowing, thick, healthy lawns crowd out weeds. Healthy
lawns are better able to tolerate insects, drought, heat, and other environmental stresses.
Keep the environment healthy by following proper safety procedures. Apply only to the lawn. When fertilizer is
left on driveways, sidewalks, or patios, rain or watering can ush the stray particles into the street, where it
eventually makes its way to storm drains and surface waters.
Leave the grass clippings on your lawn. Leaving grass clippings on your lawn recycles plant nutrients back into
the soil. Clippings contain the same benecial nutrients as fertilizer. Sweep or blow clippings from hard surfaces
back onto the lawn where these benets can be realized
.
Slide lever
to ON position
to activate.
TMTM
ELITE
SPREADER
TMTM
ELITE
SPREADER
OFF
ON
1
2
TAPERED OVERLAP
SWATH WIDTH
Register your spreader at scotts.com/registerspreader for exclusive product oers, My Turf emails,
life-long support through the Scotts Help Center, and more!
Para obtener las instrucciones de uso en español, por favor visite www.scotts.com/elite o llame al 1-800-543-8873
Parts Included In The Hardware Kit:
How to Assemble Your Elite Broadcast Spreader:
• Remove spreader and hardware kit from the box. Check to make sure you have all the parts.
• Slide one wheel onto each end of the axle (item a). The left side of the axle has a pin (item b)—
make sure the pin ts into the slot on the wheel.
• Slide one washer onto each end of the axle (item c).
• Insert one cotter pin into the hole at each end of the axle (item d).
Bend the cotter pin legs around the axle so the wheels are secure (item e).
• Snap the hubcaps onto the tires (item f).
• Recycle all cardboard material.
How to Use Your Elite Broadcast Spreader:
• Raise the handle, and tighten wing nuts by hand.
• Turn the orange rate control dial to the correct setting listed in this instruction pamphlet.
• Fill the spreader over a patch of bare ground or driveway/sidewalk.
Do not ll spreader on the lawn. Clean up any product that spills onto hard surfaces.
• To apply product, begin walking, then squeeze and hold the trigger.
Note: To avoid potential lawn damage, always push spreader in a forward motion when applying fertilizer.
Release trigger at turns or when you stop. The EdgeGuard® Landscape Protection System blocks o the
right side of the spread pattern to prevent product from spreading onto non-lawn areas.
Spreader Settings:
For a complete list of products and settings visit www.scotts.com/elite or call 1-800-543-TURF (8873)
Scotts® Turf Builder® Weed & Feed 3 ½
Scotts® Turf Builder® Bonus® S Southern Weed & Feed 3 ¾
Scotts® Turf Builder® Halts® Crabgrass Preventer with Lawn Food 3 ½
Scotts® Turf Builder® Lawn Food 3 ½
Scotts® Turf Builder® Triple Action 4 ½
Scotts® Turf Builder® Southern Triple Action 4 ¼
Scotts® Turf Builder® Annual Program Early Spring (Regular Rate) 3 ½
Scotts® Turf Builder® Annual Program Spring 3 ½
Scotts® Turf Builder® Annual Program Summer 4 ¾
Scotts® Turf Builder® Annual Program Fall 3 ½
Step® 1 Crabgrass Preventer Plus Lawn Food 3 ½
Step® 2 Weed Control Plus Lawn Food 3 ½
Step® 3 Lawn Food With 2% Iron 3 ½
Step® 4 Fall Lawn Food 3 ¾
Scotts® Turf Builder® THICK'R™ Lawn Sun & Shade 7 ½
Scotts® Turf Builder® Grass Seed Sun & Shade Mix® (Regular Rate) 5 ½
Scotts® Turf Builder® Grass Tall Fescue Mix (Regular Rate) 7 ½
Scotts® Ice Melt 5 to 6