Operation Manual

20 scott-sports.com 21
GENIUS LT
BIKE OWNER’S MANUAL
ENGLISH
Please refer to the following instruction:
Ride your bike off a pavement (remain in the saddle) and check how many times
it bounces.
- If it bounces 1-2 times, the set up is good.
- If it bounces more than 3 times the rebound is too fast. Turn the knob 1-2
“clicks” clockwise
- If it does not bounce the rebound is too slow. Turn the knob 1-2 “clicks” counter
clockwise.
IMPORTANT:
Note that you have to mount the FOX Nude Shock always as shown below.
Mounting the rear shock in a different position can cause severe damage to
the frame, the linkage levers and the rear shock.
Same for the FOX CTD on some of the Genius LT models.
IMPORTANT:
After a dismantlement of the rear shock, both fixing bolts should be tighte-
ned with a tightening torque of 10Nm/88in-lbs.
If this is not done correctly the rear shock can be damaged.
SCOTT strongly recommends using only the FOX Nude (FOX CTD shock)
with the Genius LT bike, as we designed both parts for a perfect matching
combination with a linear suspension rate.
Also on those shock models the SAG should be 18mm.
Other Shock Models on Genius LT
If you want to use a different rear shock model than the one originally on the
bike, please make sure that the shock will not in any position hit the frame
and cause a damage to the frame.
Please follow the instruction below:
Please make sure that the rear shock or its accessory parts do not touch the
frame when mounting or suspending.
For doing so release the air/remove the coil, install the shock and compress
the shock completely.
If the shock touches the frame while doing so, do not use this shock in order
to avoid damage to frame, swingarm or shock.
SET-UP OF OTHER SHOCK MODELS