RANGEHOOD & INSTALLATION GUIDE EV-6UCQ EV-9UCQ Revision V2_161219 www.schweigen.com.
Index 1. Before Installation Important Information 3 3 2. Maintenance & Service Led Bulb Replacement Electrical Cord For Users 4 5 5 5 3. Description Rangehood Contents Operation Cutout Size 6 6 6 6 4. Installation Rangehood Size Vs Cooktop Size Overhead Cabinet Rangehood Installation Position Recommended Installation Height For Induction Cooktop Mounting Points Overview 7 7 7 8 9 10 5. Condensation Information 11 6. Troubleshooting 12 7. Service 13 8.
1. Before Installation Important • Please read this section thoroughly before attempting to install or operate the rangehood. Inspect your product upon receipt. Any damage or defects MUST be reported within 48 hours, or no claim will be recognised.
2. Maintenance & Service • CAUTION: Accessible parts may become hot when used with cooking appliances. • We recommend this appliance be installed and repaired by a qualified technician. • It is dangerous to modify any part of this appliance. Modification of any kind, will immediately void the warranty. • The manufacturer declines all responsibility in case of failure to adopt proper safety measures. • Please consult local laws and regulations and install in accordance.
2. Maintenance & Service Incandescent Bulb Replacement • Switch off the power to the canopy hood and allow the bulb to cool. • Remove the bulb by turning it by hand in an anti clockwise direction • Care must be taken to avoid the bulb falling onto the hob top • Replace the bulb by inserting it into the socket and hand turning in a clockwise direction Electrical Cord Ensure the supply cord is not exposed to heat, chemicals or sharp objects.
3. Description Rangehood Contents 1 1. Power to external motor system 2 2. Male Plug (Main Power 240V) 3 3. Single 200mm Outlet 4. Reducer – only for Hiflow & Isodrive 650 motors 5. Filter 4 6. Light Note: Filter and light quantity may vary from model to model. 3 1 2 5 3 6 Operation This undermount is equipped with an ON/OFF switch. When the “ON” position is selected the unit will run at maximum. When the “OFF” position is selected the rangehood will turn off.
4. Installation Rangehood Size vs Cooktop Size In addition to the size, the height of the rangehood above the cooktop is important to obtain the best performance. INADEQUATE Rangehood smaller than cooking zone ADEQUATE Rangehood same size as cooking zone OPTIMAL Rangehood larger than cooking zone Overhead cabinet Rangehood Installation position It is important to consider the benchtop and overhead cabinetry depth before installing the rangehood.
4. Installation Mounting Instructions It is STRONGLY RECOMMENDED that the rangehood be installed centrally over the cooktop. This will greatly improve its performance. Minimum height from the hob top surface to the underside face of the rangehood: • 650mm electric cooktop • 650mm gas cooktop Any installation above 800mm will compromise the extraction performance. Note: If the instructions for the gas cooktop specify a greater distance, this must be taken into account.
4. Installation SIDE SIDE VIEW SIDE VIEW SIDE VIEW MOUNTING POINTS The diagrams below are a guide for all mounting points. SIDE VIEW SIDE VIEW Front View FRONT VIEW Side View Wall Cabinet A TOP VIEW B Front Mounting point A and B need to be tighted with slightly angled screws to pull the rangehood up tight to the cabinet. SIDE VIEW SIDE VIEW TOP VIEW Bottom BOTTOMView VIEW TOP VIEW These support screws insert from the bottom of the rangehood.
4. Installation Overview NOTE: For more information, please refer to motor installation guide. 1. XDrive-600 Motor 1 2. Roof Seal Kit (Dektite)* 3. Support Straps* 4. Attach Flexi Duct to BellMouth Adaptor using duct tape and cable tie. DO NOT rip the ducting. 2 3 5. Motor Power Lead (Male Plug) 4 5 6. Rangehood to Motor Lead (Female Plug) 6 7. Main Power Lead (Male Plug) 8 7 9 8. Flexi Ducting must be pulled taut. DO NOT crush or kink the ducting. Keep ducting secured in place. 9.
5. Condensation Information Cooking with Induction Cooktops Cooking with an induction or similar cooktop, may produce condensation on the rangehood. Unlike basic electric or gas cooking, induction cooktops heat food and liquid instantly, which in turn, produces vapours rapidly. Because of this rapid process, the rangehood filters do not have enough time to warm, which increases the chance of condensation forming.
Check rangehood’s motor switch. Ensure that there is power to the rangehood, the motor is connected to the rangehood and the rangehood is switched on. Rangehood does not work X X Light does not work X Rangehood air suction is weak X X Rangehood does not direct air out X X Loud noise from the rangehood X Page 12 X X X X X Check motor to make sure it hasn’t been obstructed or damaged by flying debris. X Check Isodrive installation manual, make sure the flexi ducting is installed correctly, eg.
7. Service Service In the event that the failure is not due to the faults mentioned in Troubleshooting, contact the customer service centre. In Australia, Customer Service 1300 829 066 In New Zealand, Customer Service 0800 200 510 Lodging an Online Service Request In the event that failure is not due the reason/s in the trouble shooting section, you can lodge an online Service Request. To lodge Service Request, visit our website https://www.schweigen.com.
8.
9. Disclaimer Disclaimer Under our policy of continuous product development, product specifications may change without notice. Prospective purchasers should therefore check with the retailer to ensure this publication correctly describes the products being offered for sale.
Australia 8/3-4 Anzed Court, Mulgrave 3170 Victoria. Phone 1300 881 693 Email sales@schweigen.com.au Web www.schweigen.com.au New Zealand 5 Tolich Place, Henderson, Auckland 0610. Phone 0800 200 510 Email info.parex@emerson.com Web www.parex.co.
