Icon 2 F1 Chassis Kit - Manual

01
www.racing-cars.com
IMPORTANT SAFETY NOTES
We strongly recommend that anyone driving RC cars, or organising events, should obtain third party liability insurance. In the UK this
can be done by joining the BRCA. www.brca.org
This product is not suitable for children under the age of 14, without the direct supervision of a responsible adult.
Select an area for assembly that is away from the reach of small children.
The parts in this kit are small and can be swallowed by children causing choking and possible internal injuries.
Exercise care when using hand tools and sharp instruments during assembly.
Carefully read all manufacturers warnings and cautions for any additional items used in the construction.
In line with our policy of continuous development the exact details of the kit may vary.
DO NOT use this car on public roads or in places where it can interfere with traffic, people or animals.
Always check the operation of the radio with the wheels off the ground, before using the car.
Make sure the radio and car batteries are fully charged before use.
Disconnect and remove the battery from the car when not in use.
Always store and charge LiPo batteries in a fireproof container.
DO NOT put fingers or any objects inside rotating or moving parts as this may cause injury.
Make sure the charger is correctly set for the type of battery you are using.
Incorrect charging may cause a fire.
Insulate all exposed electrical wiring. Exposed or damaged wires can cause short circuits and fire.
The motor and speed controller can become hot during use. DO NOT touch them immediately after using your car as this may cause injury.
ADDITIONAL ITEMS REQUIRED
TOOLS REQUIRED
ICON KEYS

















Radio Equipment
Steering Servo
Motor and Pinion Gear
Electronic Speed Controller
1.5mm Hex Driver - U2789
2.0mm Hex Driver - U2790
2.5mm Hex Driver - U2791
3.0mm Hex Driver - U2792
5.5mm M3 Nut Driver - U2795
7.0mm M4 Nut Driver - U2796
Body Reamer - U2818
Pliers - CR528
Side Cutters - CR527
Soldering Iron - CR275
Solder - CR655
Curved Scissors - CR044
3.5mm Phillips Driver - AM140134
2S Shorty LiPo
Polycarbonate Paint Pro Tyre Glue
Battery Charger
Wheels, Tyres and Inserts
www.racing-cars.com
CORE RC Medium Thread
Lock 3ml - CR520
THREAD LOCK
CORE RC 522 Pro Tyre
Glue 20g + 2 Nozzles - CR522
CA GLUE
Caution/Important note. Please read.
!
CORE RC High Performance
Lithium Grease10ml - CR752
LITHIUM GREASE
Left-Hand Side of car
LH
Right-Hand Side of car
RH
Additional information that will help you
build a faster race car.
RACE TIP
Set up Sheet - Refer to page 24.
www.racing-cars.com
Driver: Date: Event/Track:
Qualify: Final: Best Lap:
FRONT SUSPENSION
SET UP SHEET
REAR SUSPENSION
SHOCKS
FRONT
Notes:
REAR
Body
Piston
Oil
cSt
cSt
Spring
lb/in
lb/in
Limiters (i)
mm
mm
Stroke
mm
mm
Limiters (e)
mm
mm
Cap
V S A
V S A
KEY: P = Plastic, A = Alloy, B = Brass, CF = Carbon Fibre, S2 = Schumacher Composite,
M = Medium, S = Stiff, Sh = Short, H = High, L = Low, F = Front, R = Rear, Y = Yes, N = No
KEY: P = Plastic, A = Alloy, B = Brass, CF = Carbon Fibre, S2 = Schumacher Composite,
M = Medium, S = Stiff, Sh = Short, H = High, L = Low, F = Front, R = Rear, Y = Yes, N = No
V = Vented, S = Sealed, A = Aeration
Ride Height
mm
Bump Steer Washers
mm
5
4
3
2
2
2
1
3
2
1
1
1
2
2
3
4
2
3
4
5
1
1
A
A
A
B
B
C
B
S2 CF
P A
mm
0˚
5˚
Hub Height
H L
M
Pivot Block Height
H L
M
M CF
S
Toe
Camber at Ride Height
deg
Anti Roll Bar
0.9 1.1 1.2 1.3
Wheelbase
0 +1.5 +3.0 +4.5
Front Wing
Y N
Notes:
Notes:
Ride Height
mm
Wing Gurney Height
mm
Driveshaft Type
CVD U/J
Camber at Ride Height
deg
Anti Roll Bar
1.1 1.2 1.3 1.4
1.0
Toe
3° 2.5° 2° 1.5° 0.5°
3.5°
4°
1.0°
Anti-Squat
1° 2° 3° 4°
-0.75 0.75
0
Hex
Yoke
Shock Mount
Link Height
S2 CF
A
Link Mount
Wishbone
Hub Carrier
P A
TRANSMISSION
TRACK TYPE
Motor
Rotor Dia.
mm
Timing
deg
Type
Grip Level
Spur
t
Pinion
t
Condition
Surface
P B
A
Pivot Block
21 12
mm
Ackermann
1
Centre Track Rod
P A
Di Height
H M L
High Medium Low
Tight Open Mixed
Weather
Flat Bumpy Mixed
Clay Long Astro Carpet
Grass Short Astro Mixed
Slipper Plates
2 3
Di Type
B 2g 4g
Motor Plate
A CF
Lock Out
Y N
CHASSIS
Side Pods
Chassis
1 2 3 4 5 6 7 8
Rearward Shock Position Only
A B
S C/F
A C/F
EQUIPMENT
WEIGHTS
E.S.C.
Servo
RX
LiPo
Bodyshell
LiPo Position
Chassis Insert
X Brace
Running Weight
Notes:
S2 CF
Shock Mount
mm
Link Height
M CF
S
Wishbone
2
1
AP
Link Mount
NY
Low Roll Centre Shim
-0.75 0.75
0
1.5 3.0
2.25
Hex
Y N
0mm +5mm
g
Radio Tray
Chassis
Rear Strap
Radio Tray
Under LiPo
F R
F R
Y N
Y N
Wheelbase
Sh L
M
1 2 3
Di Oil
cSt
mm
Hub Washers
LH
Pin Hole
E
C
D
Notes:
deg
In Out
Trish Neal N/A Tests / Multiple
N/AN/A N/A
18
18
5
1.0
-1.0
-1.0
12K
Kit
550
0 0
0 0
22.0 27.3
White 1.5 3 Hole
Black 4.0 Green 2.2
Red 1.7 3 Hole
400
Kit
7.0 Turn
12.3
20
23
LRP Flow X
KO RSX 3
Sanwa
LRP 4000
Sunny
FRONT REAR
Wheels
Inserts
Tyres
TYRES
Notes:
Yellow Stagger
Kit Kit
None Medium
Yellow MEZZO
Kit
80 1500
2
2.5
4
2