Conext Gateway Installation

NOTICE
EQUIPMENT DAMAGE
n All cables connected to the Conext Gateway must run indoors and not be susceptible to
lightning strikes.
n Turn OFF all devices before connecting cables. The Conext Gateway does not have an
ON/OFF switch.
n Do not connect an Ethernet cable from the Conext Gateway to the WAN/MODEM port on
the network router.
n Do not connect an Ethernet cable plug into a Xanbus port on the Conext Gateway.
n Do not connect a Xanbus RJ-45 cable plug into the 10/100 Ethernet port of theConext
Gateway.
n Do not connect any port on the Conext Gateway to an outside line or to a public
telecommunication network.
n Ensure that the device connected on the Xanbus network is in standby mode before
changing settings. Do not change any settings unless you are familiar with the device.
n Changes to any TCP/IP-related settings should only be performed by a qualified IT
professional.
Failure to follow these instructions can result in equipment damage or affect network
performance.
NOTICE
EQUIPMENT DAMAGE
n Do not disassemble the Conext Gateway.
n See Warranty for instructions on obtaining service.
n The Conext Gateway contains no user serviceable parts. Attempting to service the Conext
Gateway yourself will void your warranty.
Failure to follow these instructions can result in equipment damage.
NOTE: This device can be configured to connect to the Internet using port-forwarding in
your network router’s settings. There is a security risk in port-forwarding unencrypted
network traffic over a public network (Internet). Use of a VPN or a secure tunnel to route
Conext Gateway communication via the Internet is recommended.