User's Manual

8
WPR400 Wireless Portable Reader User Guide
CHANGE THE RF CHANNEL
!
Changing the RF channel will terminate links with other WAPMs previously linked to the
PIM400.
The WPR400 radio frequency (RF) channel is controlled by the PIM400 it is linked with. The RF
channel in use may be changed on the PIM400 through the Schlage Utility Software (SUS).
Follow these steps to change the RF channel on the WPR400.
1. Start communication between the PIM400 and the SUS by logging in to the SUS application.
2. The SUS will display “AD400” when communicating.
3. Select “Device Options”.
4. Select “PIM Properties”.
5. Select the “Edit” tab.
6. Select a new/different RF channel.
7. Save your selection.
8. Select the “Link” tab.
9. Select a “Door Address” and click on the “Link” button.
10. Try to link again using the new RF channel.
ENABLE DYNAMIC CHANNEL SWITCHING
!
Activation of Dynamic Channel Switching will terminate links with other WAPMs previously
linked to the PIM400.
Dynamic Channel Switching (DCS) is controlled by the PIM400 the WPR400 is linked with. DCS may
be enabled on the PIM400 through the Schlage Utility Software (SUS).
Follow these steps to enable Dynamic Channel Switching on the WPR400.
1. Start communication between the PIM400 and the SUS by logging in to the SUS application.
2. When communicating, the SUS will display “PIM400-485-RSI” for the PIM400-485, or
“PIM400-TD2” for the PIM400-TD2.
3. Select “Device Options”.
4. Select “PIM Properties”.
5. Scroll down to the “Dynamic Channel Switching” menu.
6. Select one of three (3) “Enable Channel”.
7. Save your selection.
8. Try to link again using the Dynamic Channel Switching selection.