OPERATOR'S MANUAL

ManualsBrandsScania ManualsOtherScania DC13 industrial engine Operator's manual

Table Of Contents

Start-up Report – Warranty
Introduction
Environment and safety
- Environmental responsibility
- Safety
- Warnings and advisories
- Certification
Scania engines engine warranty for industrial engines
- Emission control systems warranty
- Emission control system warranty statement
California emission control warranty statement
- Your warranty rights and obligations
- Manufacturer's warranty coverage
- Owner's warranty responsibilities
SCR catalytic converter
Engine data plate
Component identification
- SCR system
Starting and running
- Checks before running
- Reductant pump
- Starting the engine
- Running
- Engine shutdown
- Checks after running
Maintenance
- Engines with few hours of operation
- Cleaning the engine
- Maintenance intervals
- Biodiesel (FAME)
Lubrication system
- Oil grade
- Oil analysis
- Checking oil level
- Changing the oil
- Labels for top-up engine oil grade
- Parts
- Cleaning the centrifugal oil cleaner
- Operational testing
- Renewing the oil filter
Cooling system
- Coolant
- Checking coolant level
- Checking antifreeze and corrosion inhibitor
- Antifreeze and corrosion inhibitor
- Changing coolant
- Cleaning the cooling system
Air cleaner
- Reading the vacuum indicator
- Renewing the filter element
- Renewing the safety cartridge
Fuel system
- General information on the XPI system
- Checking fuel level
- Renewing the fuel filter with draining nipple
- Renewing the fuel filter using a suction tool
- Bleeding the fuel system using a suction tool
Miscellaneous
- Checking the drive belt
- Checking for leaks
- Checking and adjusting the valve clearance
- Renewing the reductant filter
- Cleaning the reductant tank filler filter
- Cleaning the reductant tank ventilation filter
Diesel
- Composition of the fuel
- Sulphur content of fuel
- Temperature dependency of the fuel
Reductant for SCR
- Responsibility and quality requirements
- Properties
Preparing the engine for storage
- Handling the engine
- Preservative coolant
- Preservative fuel
- Preservative oil
- Preparations for storage
Technical data
- General data
- Lubrication system
- Injection system
- Cooling system
- Intake system
- Electrical system
Scania Assistance

OPM 200 en-GB 43

Scania CV AB 2015, Sweden

Lubrication system

17.

Refit the rotor and rotate it by hand to make

sure it rotates easily.

18. Fit a new O-ring in the cover. Refit the cover

and tighten the lock nut. Tightening torque

20 Nm.

IMPORTANT!

To reduce the risk of oil leakage it is important to

tighten the cover to the correct tightening torque.

Note:

Tool 588 651 or 2 259 530 together with a ratch-

et head is suitable for use during centrifugal oil

cleaner maintenance.

127 882

333 043