User Manual

Table Of Contents

00:23-03 en-GB 14

Scania CV AB 2014, Sweden

Lubrication system

11.

Fit a new paper insert on the inside of the ro-

tor cover. Fit the strainer onto the rotor.

12. Fit the strainer onto the rotor.

13. Fit a new O-ring by sliding it over the strain-

er.

14. Refit the rotor cover. Make sure that the O-

ring sits correctly on the inside.

15. Screw the rotor nut back on by hand.

16. Check that the shaft is not loose. Secure with

thread-locking fluid 561 200 if it is loose.

First clean thoroughly using a suitable sol-

vent. Tighten the rotor shaft using socket

wrench 99 520. Tightening torque 27 Nm.

Note:

Take care not to damage the rotor shaft.

234

337 178

127 881