Manual

BOLT PULLED TO THE REAR - THE MUZZLE
POINTED IN A SAFE DIRECTION - THE SAFE-
TY IN THE MID SAFE POSITION, THE TRIG-
GER SHOULD NOT HAVE ANY REARWARD
MOVEMENT.
SAFETY OFF – READY TO FIRE
1. The safety is in the OFF position when moved
fully forward, exposing the red “F” (see insert
in FIGURE 2).
FIGURE 2
NEVER TRANSPORT/CARRY A LOADED
FIREARM WITH THE SAFETY OFF.
SECTION 3 – MODEL 212 (BOTTOM
BOLT RELEASE)
INSTALLING AND REMOVING THE BOLT
ASSEMBLY
BOLT ASSEMBLIES ARE SPECIFICALLY
MATCHED TO A FIREARM. USING ANY
OTHER BOLT ASSEMBLY MAY CAUSE
EXTENSIVE DAMAGE TO THE FIREARM
AND/OR SERIOUS INJURY TO THE SHOOT-
ER OR BYSTANDER.
CERTAIN FIREARMS ARE SHIPPED WITH
THE BOLT REMOVED AND PACKED IN A
SEPARATE COMPARTMENT WITHIN THE
BOX. BEFORE INSTALLING THE BOLT, VER-
IFY THAT THE 4 DIGITS ENGRAVED BY THE
EXTRACTOR MATCH THE LAST 4 DIGITS OF
THE SERIAL NUMBER ON THE RECEIVER.
BE SURE THERE IS NO AMMUNITION IN
EITHER THE CHAMBER OR MAGAZINE.
BOLT INSTALLATION (SEE FIGURE 3)
1. Rotate the FRONT BAFFLE (1) to line-up the
BOLT GUIDE with the EXTRACTOR.
2. Pull the TRIGGER (2) fully rearward and hold it
in that position.
3. WITH NO AMMUNITION IN THE FIREARM,
insert the BOLT (3) into the firearm, pushing it
forward.
4. Close the BOLT HANDLE (pushing downward)
and verify that the “THREE POSITION SAFE-
TY” is operational as explained in SECTION 2
of this manual.
FIGURE 3
BOLT REMOVAL – BOTTOM BOLT RELEASE
(see FIGURE 4)
1. With the muzzle pointed in a safe direction,
move the safety forward to the SAFETY OFF
– READY TO FIRE position.
2. Lift the bolt handle and pull fully to the rear.
3.
WITH NO AMMUNITION IN THE FIREARM,
pull the TRIGGER (1) fully rearward and hold
it in that position.
4. Push the BOLT RELEASE (2) as far as it will
go into the trigger guard.
5. Grasping the BOLT HANDLE, pull the bolt
assembly fully rearward until it clears the
receiver. If it seems to bind or stop, be sure
that the trigger has been pulled fully rearward
first and then the BOLT RELEASE pushed as
far as it will go into the trigger guard.
6