Instructions / Assembly

Step 8
416868 www.sauder.com/servicesPage 12
VIEW THE T-LOCK BOX VIDEO
å
Fasten the DRAWER BACK (D158) to the DRAWER
SIDES (D12 and D13). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D964) inserts into
the groove of the DRAWER BACK (D158).
12
3
å
Insert the DRAWER SIDES (D12 and D13) at an angle
into the slot at each end of the DRAWER FRONT (H).
å
Slide the DRAWER BOTTOM (D964) into the grooves in the
DRAWER SIDES (D12 and D13) and DRAWER FRONT (H).
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
Groove
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
D12
D13
D964
D158
D12
D13
D964
D13
H
H
Unfi nished
surface
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
D12
4
å
Fasten the DRAWER FRONT MOLDING (I) to the
DRAWER FRONT (H). Use two BLACK 1" PAN
HEAD SCREWS (60S).
H
I
BLACK 1" PAN HEAD SCREW
(2 used in this step)
60S
These edges
should be even.
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
30S