User Manual

ManualsBrandsSANYO ManualsLCD ProjectorPLCXL50

Setting

Remote control

This projector provides two different remote control codes;

the factory-set, initial code (Code 1) and the secondary code

(Code 2). This switching function prevents remote control

interference when several projectors or video equipment

are operated at the same time.

When the projector is operated in “Code 2,” both the

projector and the remote control must be switched to

“Code 2.”

To change the code for the projector:

Select either “Code 1” or “Code 2” in this Setting Menu.

To change the code for the remote control:

Press and hold both the MENU and IMAGE buttons

together for more than 5 seconds. After changing the code,

make sure the remote control operates properly.

Remote control

Press and hold

MENU and

IMAGE buttons

for more than 5

seconds.

✔Note:

• When different codes are set on the projector and on the

remote control, any operation cannot be made. In that

case, switch the code on the remote control to fit the

code on the projector.

• if the batteries are removed from the remote control for a

long period of time, the remote control code will be reset.

Security (Key lock, PIN code lock, Alarm settings)

This function allows you to use the Key lock, PIN code lock,

and Alarm function to set the security for the projector

operation.

Key lock

This function locks the top control and remote control

buttons to prevent operation by unauthorized persons.

..... Unlocked.

..... Lock the operation of the top control. To

unlock, use the remote control.

..... lock the operation of the remote control.

To unlock, use the top control.

If the top control accidentally becomes locked and

you do not have the remote control nearby or there is

something wrong with your remote control, contact the

dealer where you purchased the projector or the service

center.

Key lock

Select Key lock. Use

the Point ed buttons

to choose one of the

options and select

[Yes] to activate it.