User Manual

46
Display
Blue back
Press the Point 7 8 buttons to switch on/off. When this
function is “On,” a blue image is displayed while the input
signal is not detected.
Press the Point 7 8 buttons to switch on/off. This function
decides to display the On-Screen Displays.
On ………………… Display all the On-Screen Displays.
Use this function when you want
to project images after the lamp
becomes bright enough. This mode is
set as a default.
Countdown off… Display the input image instead of
the countdown when turning on the
projector. Use this function when you
want to project the image as early as
possible even when the lamp is not
bright enough.
Off………………… Do not show the On-Screen Displays.
except:
●On-Screen Menu
● “Power off?”
●P-Timer
● “No signal” for Power management item (p.50)
●”Please wait...”
●Arrows for panning mode (pp.36)
Setting
Uniformity adj.
This function adjusts the brightness uniformity on a screen.
Select either Store 1, Store 2 or Reset with the Point 7
8 buttons, and then press the SELECT button. Press the
Point 7 8 buttons to adjust the brightness uniformity (from
0 to 7).
Store 1…… Store the uniformity adjustment even
when the projector is turned off. Reset the
uniformity adjustment when the AC power
cord is unplugged.
Store 2…… Store the uniformity adjustment even when
the projector is turned off or the AC power
cord is unplugged.
Reset…….. Reset the Uniformity adjustment when the
projector is turned off or the AC power cord
is unplugged.
✔Note:
• Sometimes, the brightness uniformity can not be
adjusted under certain conditions. With the adjustment
of brightness uniformity, the balance of color or contrast
also changes.