Owner`s manual

13
Part Names and Functions
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.
Open the battery
compartment lid.
Install new batteries
into the compartment.
Replace the
compartment lid.
Two AAA size batteries
For correct polarity
(+ and –), be sure
battery terminals are
in contact with pins in
compartment.
1 2 3
Point the remote control toward the projector when pressing
the buttons. Maximum operating range for the remote
control is about 16.4'(5 m) and 60 degrees in front of the
projector.
Remote Control Operating Range
Remote Control Battery Installation
16.4'
(5 m)
30°
Remote control
30°
Remote Control Code
Press and hold the MENU and IMAGE buttons for more than
five seconds to switch between the Code 1 and Code 2. The
initial code is set to Code 1.
MENU button
IMAGE button
The 2 different remote control codes (Code 1 - Code 2) are assigned to this projector.
Switching the remote control codes prevents interference from other remote controls when
several projectors or video equipment next to each other are operated at the same time.
Change the remote control code for the projector first before changing that for the remote
control. See "Remote control" in the Setting Menu on page 56.