Projector User Manual

EN-18
Powering On/Off the Projector
Powering On the Projector:
1. Remove the projector lens cap.
2. Complete the AC power cord and peripheral signal cable(s) connections.
3. Press I/ button to turn on the projector.
The projector takes a minute or so to warm up.
4. Turn on your source (computer, notebook, DVD, etc.). The projector automatically detects
your source.
 If you are connecting multiple sources to the projector simultaneously, press the
INPUT button.
Warning:
 Remove the lens cap first before powering on.
 Never look into the lens when the lamp is on. This can damage your eyes. It is
especially important that children are not allowed to look into the lens.
Powering Off the Projector:
1. Press I/ button to turn off the projector lamp. You will see a message "Power off? Press
Power again" appear on the screen.
2. Press I/ button again to confirm.
 The cooling fans continue to operate for cooling cycle.
 When the LAMP LED begins flashing, the projector has entered stand-by mode.
 If you want to turn the projector back on, you must wait until the projector has
completed the cooling cycle and has entered stand-by mode. Once in stand-by mode,
simply press I/ button to restart the projector.
3. Disconnect the AC power cord from the electrical outlet and the projector.
 Faster on-off-cycles will damage the lamp and reduce lamp life. Wait at least for 5
minutes to turn off the projector after powering on.
 When the projector is in standby mode, LAMP LED and TEMP LED will flash once
then go out, and the fan will also turn for one second. This is normal, and not a
malfunction.