User's Manual

18
The preparation display will disappear after 30
seconds.
(See page 53 for Lamp control status.)
Turning On the Projector
Connect the projector’s AC power cord into an AC
outlet. The POWER indicator lights red. Open the lens
cap (see pages 8, 61).
Press the ON/STAND-BY button on the top control or
on the remote control. The POWER indicator lights
green and the cooling fans start to operate. The
preparation display appears on the screen and the
countdown starts.
2
3
1
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
Selected Input Source and Lamp Control
✔Note:
The Filter warning and Lamp replacement
icons may appear on the screen depending
on the usage state of the projector.
Basic Operation
Lamp control status
Video
4
After the countdown, the input source that was selected
the last time and the lamp control status icon (see page
53) appear on the screen.
✔Note:
• When the Logo select function is set to Off, the logo will
not be shown on the screen (p.46).
• When Countdown off or Off is selected in the Display
function, the preparation display will not be shown on
the screen (p.45).
• When the Input Search function is set to On2, the input
signal will be searched automatically (p.44).
• When Off is selected in the Display function, the Video/
PC selection window and the input signal guidance
window are not shown on the screen. (p.45)
5
If there is no signal input when start on the projector,
or the current signal is missed while operating the
projector, the Video/PC selection window will be
displayed on the screen, please move the pointer to
input source desired by pressing the Point ▲▼ buttons
and press the SELECT button. And then follow the
input signal guidance window to correct the signal and
connection.
If the projector is locked with a PIN code, PIN code input
dialog box will appear. Enter the PIN code as instructed
on the next page.
Video / PC selection window
Input signal guidance window
Video / PC selection window
Input signal guidance window
Project Video
Project Computer
Cancel
Project Video
Project Video
Project Computer
Cancel
Project Computer
No signal
Current Input setting:Video
Is signal processed correctly?
Is cable connected properly?
No signal
Current Input setting:RGB
Is signal processed correctly?
Is cable connected properly?
Remote Control of the document camera
POWER button
Note:
- The projector can be turned ON or OFF by pressing
the POWER button on the remote control of the
specified document camera ("L-1ex/TT-02RX").
- The projector can be turned off with this remote by
pressing once; however, the "Power Off?" indicator on
the screen will not be displayed.
- While the POWER indicator is blinking, the lamp is
being cooled down and the projector cannot be turned
back on.
16