Installation Instructions

64
When this happens...
Symptom Cause Measure
There is no power. Batteries are consumed.
Batteries are placed improperly.
Replace with new batteries or
recharged batteries.
Reinstall the batteries as the polarity is
indicated.
Power is cut off
occasionally.
Bad connection of connectors. Bring to Sanwa Service
Insufficient length Batteries are consumed.
Alarm will not stop. Battery voltage of the transmitter
is decreasing.
Replace with new batteries or recharged
batteries.
There is no click
sound when pressing
the key.
Volume of the BUZZER feature
is OFF (0).
Check BUZZER feature (P.56).
The servo speed is
slow.
SPEED feature is set to minus. Check SPEED feature (P.20).
Battery voltage of the receiver
is decreasing.
Replace with new batteries or recharged
batteries.
Linkage of the car body side is
heavy.
Check if the Linkage of the car body
side moves lightly.
Trim neutral is not aligned. Align Trim and reset EPA. (P.29, 30)
Rudder angle settings of D/R
and EPA are too large.
Set either value to below 100%.
(P. 19, 27, 28)
The servo will not
move when operating
Trim.
One side of the Trim movement
range is full.
Reset the servo horn and the Trim
center. (P. 29. 30)
Rudder angles of left
and right are different
even when they are
aligned.
When operating,
the servos will not
work on both ends
Replace with new batteries or
recharged batteries.
If the problem cannot be solved,
please contact Sanwa Service
Not working even if
turning on transmitter
and receiver.
Bind is not completed.
Different Model-Data and
Safety Link No.
Please check Model-Data and Safety
Link No. on transmitter.
Please bind with receiver.