User's Manual

90478 2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE

1) From within the TRIM menu, scroll UP or DOWN to highlight the REV value you would

like to change for either TRM1, TRM2, TRM3 or TRM4.

2) Press the ENTER key, then scroll UP or DOWN to choose the desired REV value for Trim

Switch Trm1, Trm2, Trm3 or Trm4.

TRIM REV setting range is NOR and REV. The default setting for all Trim Switches is NOR.

Changing the Rotary Dial Function:

1) From within the KEY ASSIGN menu, scroll UP or DOWN to highlight DIAL.

2) Press the ENTER key. The DIAL menu will be displayed and FUNCTION AUX1 will be

highlighted.

3) Press the ENTER key, then scroll UP or DOWN to choose the desired function for the

Rotary Dial. A list of functions that can be assigned to the Rotary Dial is shown in the

table on pages 55 and 56.

Changing the Rotary Dial Step Value:

The Step function allows you to adjust how far the servo travels when the Rotary Dial is turned. You can increase the Dial

Resolution by decreasing the Step value, so that the servo travels less when you turn the Rotary Dial. This makes it possible to

fine-tune servo movement extremely accurately .

Alternately, you could decrease the Dial Resolution by increasing the Step value, so that the servo travels more when you turn

the Rotary Dial. This setting may not be as accurate, although it allows you to command large amounts of servo travel at

a time.

1) From within the DIAL menu, scroll UP or DOWN to highlight STEP 5.

2) Press the ENTER key, then scroll UP or DOWN to choose the desired Step value for the

Rotary Dial.

DIAL STEP setting range is 1 to 100. The default setting is 5. The Step value is a percentage

of servo travel.

Changing the Trim Switch Direction of Travel:

The direction that the Trim Switches move the servos can be changed from Normal to Reverse. In Normal mode, the Trim

Switches will move the servos toward the High Side when the Trim Switches are pushed Forward. In Reverse mode, the

Trim Switches will move the servos toward the Low Side (the opposite direction) when the Trim Switches are pushed Forward.

03.KEY ASSIGN

(

KEY ASSIGNMENTS

)

SYSTEM

Changing the Rotary Dial Direction of Travel:

The direction that the Rotary Dial moves the servo can be changed from Normal to Reverse. In Normal mode, the Rotary Dial

will move the servo toward the High Side when the Rotary Dial is turned clockwise. In Reverse mode, the Rotary Dial will move

the servo toward the Low Side (the opposite direction) when the Rotary Dial is turned clockwise.

1) From within the DIAL menu, scroll UP or DOWN to highlight REV NOR.

2) Press the ENTER key, then scroll UP or DOWN to choose the desired REV value for the

Rotary Dial.

DIAL REV setting range is NOR and REV. The default setting is NOR.

SYSTEM

MT-4S User's Guide.indd 57 2015/10/27 14:39:11