Install Instructions

Hang Kit

Part No. 4036695

Parts Included:

1. (4) Ratchet Straps

2. (2) Brackets

3. (4) Eye Bolts (3/8 x3-7)

Tools Required:

• Tape Measure

• Level

• Screw Driver (Phillips or Regular)

to use as leverage for Eye Bolts

• Screws for TJI joists (only

applies if you have TJI joists)

Optional Tool:

• Power Drill with 1/4" Drill Bit

(to pre-drill Eye Bolt holes)

CAUTION!

MAKE SURE THE UNIT IS LEVEL AFTER INSTALLATION.

4201 Lien Rd Madison, WI 53704

•

TOLL-FREE 1-800-533-7533

•

www.thermastor.com

•

sales@thermastor.com

TS-930 5/17/16

OVER

Step 1: Gently tip the unit up on its back

end in order to have access to the bottom

foot holes.

Step 2: Secure the brackets in place by using the leveling feet and the

female threaded holes. (Leveling feet are packaged with the dehumidiﬁer.)

Line up the pre-drilled holes on the brackets with the leveling feet holes on

the unit (Image A). Once lined up, screw in the leveling feet to secure the

brackets to the dehumidiﬁer (Image B).

If installing the hang kit on the 70 pint unit, turn the brackets over and

secure them to the bottom of the dehumidiﬁer using the pre-drilled holes

and leveling feet. (Image C).

There are four leveling feet to screw in on each dehumidiﬁer.

Once in place, gently tip the unit back down on the leveling feet with the

brackets in place (Image D).

C. D.

Standard Joist Instructions

[SEE PAGE 3 FOR TJI JOIST INSTRUCTIONS]

PAGE 1
Hang Kit Part No. 4036695 Parts Included: 1. (4) Ratchet Straps 2. (2) Brackets 3. (4) Eye Bolts (3/8 x3-7) 3 Tools Required: • Tape Measure • Level • Screw Driver (Phillips or Regular) to use as leverage for Eye Bolts • Screws for TJI joists (only applies if you have TJI joists) 1 2 Optional Tool: • Power Drill with 1/4" Drill Bit (to pre-drill Eye Bolt holes) CAUTION! MAKE SURE THE UNIT IS LEVEL AFTER INSTALLATION.
PAGE 2
Step 3. Determine the placement of the unit and turn / screw your first eye bolt into position on the bottom of the floor or rim joist. Use a screw driver as leverage to tighten the eye bolt. Screw in until the threads are no longer visible. Step 7: Using the ratchet end of the ratchet strap, attach each strap to the eye bolts above the unit. If additional slack on the rope is needed, push the trigger on the ratchet end of the strap up and feed the rope through as needed.
PAGE 3
TJ I Joist Instructions CAUTION! SCREWING THE EYE BOLTS DIRECTLY INTO THE BOTTOM FLANGE ON THE TJI JOIST WILL WEAKEN THE STRUCTURAL INTEGRITY OF THE JOIST. When working with TJI floor joists, follow the standard instructions on the previous pages but factor in the following modification listed below: A 2”x4” piece of wood can be cut to fit between two joists. Standard floor joists are 16" o.c. (on center) apart from one another. Measure and cut the 2"x4" accordingly to fit as shown in the diagram below.