260 02.11 IND1 IMPORTANT DO NOT RETURN ANY MERCHANDISE TO THE VENDOR For Customer Service, Returns or Technical Questions, please call Saniflo’s technical support toll-free at 800-571-8191 (USA). The user should retain these instructions for future reference This product must be installed in strict accordance with local plumbing codes. Product should be installed by a licensed plumber.
03.
PAGE 3 15 feet B E B Ø 3/4” or 1” 7e 7c I 8 14 B SANIPRO ® SFA SANIFLO A C 120 V - 60 Hz - 4/10 HP - 7,2A - IP44 6,8 KG E F D 28c 28a 21e 28b 21d 28b G 28b 21c 31 21a 37 60 28b 2a 2b 24 4 7 5 3 18 8 48 10 14 20b 50 12 39 38 13 41 9 1 17 59 40 15 30 58 30 36 35 34 56 32 30 57 28b SANIPRO®
1 Introduction This macerator is manufactured in a factory which is quality certified to ISO 9001 (2000) accredited by AFAQ.This equipment benefits from the latest technological innovations concerning soundproofing.To benefit fully from the advantages provided by this new generation of appliances, it is important to comply with the installation instructions. 1.1 - GENERAL DESCRIPTION The macerating unit is a residential pumping system for toilet and bathroom fixtures.
3 4
4.2 - DISASSEMBLY FOR LITTLE intervention As the unit is connected to the water and electrical supply, it is important to check that the following actions have been taken before removing the unit: 1. If possible, close off the water supply to the tank and close the ball or gate valve on the outlet pipe. 2. Pull the electrical cord out of the receptacle before removing unit. 3. Empty out as much water as possible from the toilet tank and the toilet bowl. 4. Disconnect toilet from unit.
6 ADVICE PIPE SUPPORTS All sanitary pipe work must be supported, in accordance with the pipe manufacturer’s recommendations. Avoid dipping or trapping, which may cause the build up of residual “solids” and sub- sequent blockage. SOIL STACK CONNECTION All discharge pipe work must be connected to the soil stack by an appropriate and approved connection. A “tee” or ”y” fitting as shown is preferable. BENDS Where possible long sweeping bends should be used. Do not use short elbows.
7 Trouble Shooting Guide PROBLEM CAUSE REMEDY Motor turns normally but the water evacuates slowly from the bowl, (flush incomplete). Discharge pipe blocked or valve not vented properly. Clean out the piping and air breather hole. Waste build up in bowl. Inadequate water supply from reservoir. Check and/or adjust water level in reservoir. The macerating unit does not start up. Water does not evacuate. Power supply off. Thermal overload cut out. Wait for thermal overload to engage (approx. 20 min).
LIMITED WARRANTY 2 Year Warranty from Date of Purchase Subject to the terms and conditions set out below, SFA-SANIFLO INC., (hereafter designated the as the Company) warrants that it will repair or replace the product or any of its component parts, at the Company’s discretion if it deems that the product or part it is defective or does not meet the rated performance due to a maufacturing or material default.
NOTES :
NOTES :
US ® 18 REMOVAL « »« 20 PARTS » DISCONNECT THE ELECTRICAL POWER SUPPLY bEFORE ANY SERVICE REMOVINg THE TOILET FROM THE MACERATOR 1 Disconnect the electrical power supply. 2 Turn off the water feed to the toilet tank. Bail out as much water as possible from the tank. 3 Close or drain down any vertical discharge pipework and remove discharge hose from elbow. 4 Disconnect any inlet pipes from the unit.
