User manual

Installing a Hard Drive

Remove the screw on the back cover as illustrated. Slide the back

cover in the direction of the arrow.

Use only 2.5” IDE/PATA/ATA-6/ATA-100 (44 pins) hard drive that is

less than 10mm in thickness. Ensure that the hard drive is set to

Master. Insert the hard drive in the direction as shown in the above

diagram with the hard drive information sticker facing outwards

and hard drive circuit board facing inwards. Ensure that the male

pins of the hard drive align properly and insert fully into the female

socket on the COLORSPACE. Some of pins on the hard drive may be

unused but if the hard drive is installed properly, you will be able to

close back the back cover. If you cannot close the back cover

properly, check that you have installed the hard drive correctly.

Note

Refer to this section only if you have purchased a

COLORSPACE (casing only) without a hard drive installed or

if you plan to upgrade or change the internal hard drive.

Hard drive connector socket

2.5” hard drive

18650 Li-ion battery

Basic Operation

Direction of proper hard drive insertion

Note

Do not turn on the COLORSPACE without the back

cover in place.