Operation Manual

14
11. If you make an error use either the Back key on the remote control
to delete the character entered, or give a long press on the Select
control. Use the left and right arrows to move the block cursor to
access incorrectly entered characters.
12. After the final character of the WEP or WPA key has been entered,
locate the ‘END’ symbol and press the Select control. (The ‘END’
symbol is located between the punctuation symbols and the
numbers 0 - 9.) The radio should now be able to connect to
the network.
After you have connected to your network
1. Once connected to your radio to the network (and therefore also to
the Internet) it will display the main Mode menu. This menu provides
access to all major functions of the radio. There are also buttons on
the remote control for each of the Mode menu options except for the
Configure menu.
2. Rotate the Select control until the ‘Off’ option is highlighted on
the display.
GB