User Manual

English _9
●● OVERVIEW
Item Description
a
Illumination Sensor Detects incoming light to control the IR LED.
b
Lens Lens for the camera.
c
IR LED These infrared LED’s are controlled by the illumination sensor.
d
Audio and alarm cable port
Port to connect audio and alarm cables.
ARM-IN Used to connect the alarm input sensor or external day/night sensor.
ARM-OUT Used to connect the alarm output signal.
GND These are common ports to connect alarm input/output signals.
MIC Used to connect to a microphone.
SPEAKER Used to connect to speakers.
e
Microphone hole
Microphone is embedded.
f
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that DHCP can be
enabled. If there is no DHCP server in the network, you must run the IP Installer
program to change the basic network settings such as IP address, Subnet mask,
Gateway, etc., before you can connect to the network.
g
Test Monitor Out
Output port for test monitoring the video output. Use the test monitor cable to connect to a
mobile display and check the test video.
h
MICRO USB port
Port to connect the Wi-Fi dongle.
You can check the installation video through the applications installed in the smartphone.
Refer to “Connect to WiFi dongle” on page 17.
`
Remove the inner cover when connecting to Micro USB terminal.
`
Wifi dongle and OTG gender are sold separately.
i
Power Port Port for power terminal block.
j
Network Port Used to connect the PoE or Ethernet cable for network connection.
k
Micro SD Memory Card
Compartment
Compartment for the Micro SD memory card.
l
Inside cover Protective cover for the main body.