Use and Care Manual
Table Of Contents
- OID73951_IB_H100D-MD_SimpleUX_EN_231110
- OID73951_IB_H100D-MD_SimpleUX_CFR_231110
- Consignes de sécurité
- Remarques importantes sur les consignes de sécurité
- Symboles de sécurité importants
- CONSIGNES DE SÉCURITÉ IMPORTANTES
- AVERTISSEMENT CONCERNANT LA PROPOSITION 65 DE L'ÉTAT DE CALIFORNIE
- Avertissements importants concernant l'installation
- Mises en garde concernant l'installation
- Avertissements importants concernant l'utilisation
- Mises en garde concernant l'utilisation
- Avertissements importants concernant le nettoyage
- Précautions pour prévenir le gel
- Notification de réglementation
- Installation
- Avant de démarrer
- Opérations
- Maintenance
- Dépannage
- Caractéristiques techniques
- Consignes de sécurité
- OID73951_IB_H100D-MD_SimpleUX_MES_231110
- Información sobre seguridad
- Lo que necesita saber sobre las instrucciones de seguridad
- Símbolos de seguridad importantes
- INSTRUCCIONES DE SEGURIDAD IMPORTANTES
- ADVERTENCIA DE LA PROPOSICIÓN 65 DE CALIFORNIA
- Advertencias fundamentales para la instalación
- Precauciones para la instalación
- Advertencias fundamentales para el uso
- Precauciones de uso
- Advertencias fundamentales para la limpieza
- Cuidados para prevenir el congelamiento
- Aviso regulatorio
- Instalación
- Antes de comenzar
- Funcionamiento
- Mantenimiento
- Solución de problemas
- Especificaciones
- Información sobre seguridad
English 45
Installation check codes
Check code Meaning Solution
No problems
detected
Vent condition is good.
Vent is nearly
clogged
Over 80 % of the vent is clogged.
(This may lead to poor drying
performance or cause malfunction)
1. Clean the lint filter.
2. Check your vent condition. (Refer to
the “Ducting requirements” section)
* You must take measures (such as
cleaning) through expert personnel.
Leave the dryer at
room temperature
The internal temperature of the dryer is
too low (below 32 °F (0 °C)) or too high
(over 104 °F (40 °C)) and therefore vent
blockage cannot be detected.
Leave the dryer at room temperature
(41~95 °F (5~35 °C)) for an hour and
check again.
Items detected in
the drum
Unit is detecting items inside the drum
or there is an error on the dry sensor.
Remove items from the drum and check
again.
If the problem continues, contact a
service center.
NOTE
For other information codes, see the “Information codes” section on page 89.
Untitled-1 45 2023-11-09() 11:53:39