Use and Care Manual
Table Of Contents
- OID73951_IB_H100D-MD_SimpleUX_EN_231110
- OID73951_IB_H100D-MD_SimpleUX_CFR_231110
- Consignes de sécurité
- Remarques importantes sur les consignes de sécurité
- Symboles de sécurité importants
- CONSIGNES DE SÉCURITÉ IMPORTANTES
- AVERTISSEMENT CONCERNANT LA PROPOSITION 65 DE L'ÉTAT DE CALIFORNIE
- Avertissements importants concernant l'installation
- Mises en garde concernant l'installation
- Avertissements importants concernant l'utilisation
- Mises en garde concernant l'utilisation
- Avertissements importants concernant le nettoyage
- Précautions pour prévenir le gel
- Notification de réglementation
- Installation
- Avant de démarrer
- Opérations
- Maintenance
- Dépannage
- Caractéristiques techniques
- Consignes de sécurité
- OID73951_IB_H100D-MD_SimpleUX_MES_231110
- Información sobre seguridad
- Lo que necesita saber sobre las instrucciones de seguridad
- Símbolos de seguridad importantes
- INSTRUCCIONES DE SEGURIDAD IMPORTANTES
- ADVERTENCIA DE LA PROPOSICIÓN 65 DE CALIFORNIA
- Advertencias fundamentales para la instalación
- Precauciones para la instalación
- Advertencias fundamentales para el uso
- Precauciones de uso
- Advertencias fundamentales para la limpieza
- Cuidados para prevenir el congelamiento
- Aviso regulatorio
- Instalación
- Antes de comenzar
- Funcionamiento
- Mantenimiento
- Solución de problemas
- Especificaciones
- Información sobre seguridad
Installation
English42
STEP 10 Connect the water hose
The dryer must be connected to a cold water tap using the provided water hoses.
1. Close the cold water tap. If you have a washer’s cold
water hose attached to the cold water tap, unscrew
and remove the hose. Then, connect the female end
of the Y-connector to the cold water tap.
2. Connect the straight end of the water hose to the
Y-connector. Tighten the hose coupling by hand.
3. Using pliers, tighten the coupling an additional two-
thirds turn. Do not overtighten. You can damage the
coupling.
4. Connect the angled end of the water hose to the
filling valve at the bottom rear of the dryer. Turn the
coupling by hand until it is tight.
5. Using pliers, tighten the coupling an additional two-
thirds turn. Do not overtighten. You can damage the
coupling.
6. If you detached the cold water hose from your
washer, attach the hose to the open end of the
Y-connector, tighten the coupling by hand until it is
tight, and then, using a pliers, tighten an additional
two-thirds turn.
7. Open the cold water tap, and then check for any
leaks.
Untitled-1 42 2023-11-09() 11:53:38